Search: 2 Wire Plug   >   Watersport Carriers   >  

The newest Toyota Highlander we've installed a brake controller in is a 2014 model. I attached the install video to this page to show you the processs. The 2014 and 2018 Highlanders are the same generation though so what you see in the…

Thanks for the purchase of the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector #C56226 for your 2020 Nissan Frontier, and the 7-way will have the 12 volt pin active after the installation. Installing the…

On wiring harness #C56226 the larger brown relay is for the 12 volt circuit on the 7-Way and the two smaller blue relays are for the turn signal circuits so none of them would cause the constant power draw on the blue brake wire but I think I know…

The easiest way for you to know which replacement cable and pin you need is by the type of switch your Hopkins Engager Breakaway Kit has. If you take a look at the accompanying photo showing the two pins you can see that they are different styles. So…

Yeah I'm not sure why it was written like that. The only way to repin the #C56226 is to cut and resplice them, unfortunately.

The 2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - White #RS34FR can be mounted vertically if needed but most importantly should be installed no more than 18" from the floor so that it can accurately detect the amount of gas in…

We do offer a vent fan which can be mounted on the side of a wall, the MaxxFan Dome Roof Vent part #MA00-03812B for black or part #MA00-03812W for for white.

The first thing I recommend doing is to check that the ground wire for the lights is securely attached to a clean metal surface on the trailer frame. A loose ground wire will keep the lights from working. If the ground attached to the trailer does…

You may not even need load resistors to switch to LED lights. The best thing to do is to try the lights without load resistors first. No need to purchase something you may not need until you know need it. Load resistors such as #DI34ZR dissipate heat…

For a trailer lighting kit designed for the requirements of trailers that are over 80 inches in width we have the Optronics kit part #TL16RK which would work well. It comes with submersible taillights as well as a couple amber clearance lights.

The Wesbar Wraparound LED Tail #271594 for the passenger side and #271595 for the driver side appear that they can be the same style lights. The best way to know for sure is to measure your current lights. These two are 7-1/2 inches long, 3-1/2…

On the CR Brophy Replacement 7-Pole #R7CB the mounting holes are 3 inches apart on center.