Is the Curt Class III Trailer Hitch # 13354 on a 2009 Acura MDX Hidden or Low Profile  

It sounds like you have a 4-way trailer connector on your 2015 Ford F-350 and a 5-way connector on the 2010 GMC. The fifth pin on the 5-way connects to the truck's reverse light circuit and tells the trailer's reverse lock out to prevent the…

Wiring connections for the Electric Over Hydraulic Brake Actuator are as follows. Yellow - Cold side of breakaway switch, The wire that goes hot when a breakaway occurs. Black - Positive connection on breakaway switch, The wire that charges the…

We do have a solution for you, however, you will not be able to power reverse lights on a trailer with a 4-pin trailer connector. The reverse lights on a trailer must receive power from the reverse lights on the tow vehicle. To do this, you will want…

The wiring of the Replacement Solenoid Valve #T4748800 is ran to the reverse light circuit of the trailer's wiring connector. Basically one wire will get run to the reverse light circuit and the other wire will get grounded on the trailer frame.…

I can certainly help you with that. Since the Curt T-Connector Vehicle Wiring Harness, part #C55384 is a 4-way connector the four functions will be Yellow for the left turn and brake, Green is for right turn and brake, Brown is for running lights,…

For a Curt hitch confirmed to fit your 2011 Acura MDX that allows you to keep the full size spare tire you would want the part #13354. The spare would need to get removed during the install process but can be reinstalled once the hitch is fully…

The CURT Trailer Hitch, #13354, would be a good choice for your 2010 Acura MDX. When used with weight distribution, it has a tongue weight capacity of 500 pounds and a gross trailer weight capacity of 5,000 pounds. I have included a link to the…

For your 2008 Acura MDX we have the Curt hitch part #13354 which is a confirmed fit, and if you check out the install picture I attached you will see that it does not extend past the rear bumper at all. It actually is recessed a few inches. I also…

The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #13354 fits 2007 - 2013 Acura MDX models. I've attached a couple videos to assist, but more are available on the product page.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.