What our customers are saying:
I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future.
Kevin
Manchester, MD
Videos
for Wheel Well Liner
Help Articles
Expert Answers
The Gen-Y Weld-On 2" Receiver Tube #325-GH-003 is 2-7/8" wide on the tube and 3-1/2" wide at the collar. The overall length is 12".
In almost all cases 3,500 lb axles will all use the same bearings. If your trailer has a Lippert or Dexter 3,500 lb axle then yeah they would be the same. But to be safe it won't hurt to pull them off and get the numbers. If you are sure you…
For your 2014 Ford F-250/350 Super Duty you will want to use Wheel Masters 4-Hose Inflation Kit part #WM8001. The bend on the Wheel Masters 4-Hose Inflation Kit part #WM8001-135 causes the hoses to be in contact with your rim as soon as it comes…
Although we do not have a direct replacement for the Dicor V19582-EJN, the Replacement Wheel Master Lug Nut Cover for Wheel Liner - Qty 1 #WMRMT9061 will fit a 22 millimeter lug nut. From what I have found, the jam nut you are looking for has been…
I can absolutely tell you the difference between the two options. The Kwikee 38 Series Electric Step #LC3723383 comes with a control module, which means it will automatically extend. The Kwikee 38 Series Electric Step #LC372338 does not come with…
For replacing the Drive Head #LC34FR and Idler Head #LC87FR on a Solera Slide Topper you will want to completely remove the slide topper from your RV/Camper. You will need to insert a pin into the end of the tube end cap(see image) to keep the…
I do have options for you, but the Wheel Masters Inflation Kits are not vehicle specific parts. They are going to depend on the wheel set-up that you have. However, I can provide you with a couple of the most common options we typically see on the…
The 6-Leaf Double-Eye Spring for 4,500-lb Trailer Axles - 26" Long #e27SR will be the closest fit for your 3750 lb axle. Having leaf springs rated slightly higher is normal because you will be limited in capacity by the weakest component on your…
No, the E-Coat is not to be removed from the rotors. The E-coat is a protective coat that will prevent corrosion but it will not cause issues with coating your brake pads or have any negative impact. The Dexter Disc Brake Kit - 10" Hub/Rotor - 5…
The hub covers that I have are only available in chrome ABS finish. The Quick Trim Chrome Finish Trailer Hub Cover 6 on 5-1/2, part #QT655C, is a cover that will fit a 6 on 5-1/2 inch bolt pattern wheel. The Quick Trim Chrome Finish Trailer Hub Cover…
The best supplemental braking system for your 1984 Jeep CJ-7 is going to be the SMI Stay-IN-Play DUO Supplemental Braking System part #SM99251. The Stay-IN-Play DUO is a proportional system which means it will activate the brakes in your toad at the…
As far as a left-threaded or right-threaded cap for your motorhome, right-handed threads run clockwise, and left-handed threads run counterclockwise. The reason for this difference is that some applications of screws can come loose with the motion of…