Videos
for Toyota Highlander Owners
Help Articles
for Toyota Highlander Owners
Expert Answers
for Toyota Highlander Owners
Hey Howard! I would be happy to compare these hitches for your 2019 Toyota Highlander. The Curt #C13200 and etrailer #e98844 share the same design so the only difference is the finish. I prefer the matte black finish on our hitch since it does a…
view full answer...Depending on if your 2014 Toyota Highlander has the tow package or not will dictate where the 4-way flat plug harness will connects on your vehicle. If you have the tow package, you will use Curt #56042. The plug for this harness is located behind…
view full answer...The quickest way would be to call the service department at your Toyota dealer. If you provide your VIN, they should be able to look up your vehicle and determine if it's equipped with the tow wiring package. You can also check the fuse box as…
view full answer...We have two rear-axle suspension kits for the 2013 Toyota Highlander and one works with the 2- and the other with the 4-wheel-drive models. However, these kits are not air-bag types, but rather a micro-cellular polyurethane foam helper spring that…
view full answer...The difference between the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension part #CSS-1145R and part #CSS-1168R is that the CSS-1145R is designed for 4 wheel drive models and the CSS-1168R kit is designed for 2 wheel drive models.…
view full answer...I cannot say for sure how you can tell whether or not you have the converter on your Highlander but I can help you out with the trailer harness installation. The only sure way to tell which harness you need is to check out what wiring you have in the…
view full answer...We have the custom fit for a standard or step bumper #13028 or the deep drop bumper #41504 confirmed to fit your 1994 Ford F-150 Flareside. The Roll Pan bumper does not have a custom fit, so if you don't want the long receiver tube, I recommend…
view full answer...Hey Eric, since Curt designed the high low adapter part #C26FV for flat towing vehicles only it was never tested for a tongue weight rating and therefore it doesn't actually have one. Instead we have the Roadmaster part #RM-048-6 which also has a…
view full answer...What I would recommend is the Curt MultiPurpose Ball mount part #D210. This product will give you 6 inches of rise for your carrier without cutting the tongue weight of your hitch in half like most hitch extenders do. Check out the review video I…
view full answer...The Curt High-Low Adapter #C59KR is designed for flat towing only. Curt doesn't even test it for accessories to give it a tongue weight rating. The Roadmaster #RM-048-4 is the most comparable with a distance of 9-5/8" from hitch pin to hitch…
view full answer...When connecting two batteries together on an RV trailer you usually connect the batteries in parallel to draw 12 volts from both of the batteries. We have a photo, see photo at right, that shows how to wire the batteries in parallel. Once you have…
view full answer...Yes, the Rhino-Rack Sunseeker Awning #RR32133 comes with bolts that fit in the T-Slots on Yakima JetStream crossbars so they are compatible with each other. I have attached a review video of this for you to check out as well as the installation…
view full answer...






























