If your 2011 Kia Sorento does not have the dual exhaust system with a tailpipe on both the driver and passenger side, I recommend the Draw-Tite Class ll Hitch, part #36511. This hitch has a 1-1/4 inch receiver opening. I have attached an installation…
According to Kat's, the Kat's Heaters Custom Fit Engine Block Heater part #KH11812 will need to be installed on the drivers side of the engine in the cavity closest to the cab. This location is depicted at "LR" in the attached…
Before purchasing you are going to want to determine if the vehicle has the factory tow package or not. The definitive way to determine this is to contact a Kia dealer and have them run the VIN and they will be able to tell you how the vehicle is…
As the Draw-Tite Max-Frame Trailer Hitch Receiver #75684 was designed and tested using the threaded frame inserts, it is the only acceptable method for mounting the receiver to your 2011 Kia Sorento. You may be able to tap the holes with a M10-1.25…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
To get the rivet nut included with the Curt Trailer Hitch Receiver #C13162 for your 2005 BMW X5 to tighten up you will need to push up with the hitch very tightly to while you torque the bolt in the rivet nut to the specs provided in the instruction…
The overall dimensions of the Curt Trailer Hitch Receiver #C13073 for your 2012 Hyundai Santa Fe are 54" wide x 11" tall (drop) x 15-3/4" deep. Attached is a photo showing this. Since this is a custom fit application for your vehicle…
Short answer is we know the part #C56256 is a fit for your 2017 Kia Sorento as this harness plugs into the taillight connectors and provides the trailer wiring. Since it installs like this no tow package would be needed as all versions of the vehicle…
For a hitch, I'd recommend going with the Draw-Tite Class III hitch, part #75684 instead of the Curt hitch you mentioned. The Curt hitch warranty requirements state that a stabilizing strap like part #18050 must be used for non trailer loads like…
The #TK24FR will use the same ports as the #118269 so it would need to be replaced in order to use it. Since this only has a 7-way connection, you would also need an adapter for your scout trailer. The Pollak 7 Pole to 4 Way Connector Adapter…
Yes, your 2019 Kia Sedona without the factory tow package is still compatible with the Tekonsha OEM Replacement Vehicle Wiring Harness with Brake Controller Adapter #TK24FR. According to the manufacturer, Tekonsha, this is compatible with all models…
If your 2020 Kia Sorento has the factory tow package, there will be a tail light wiring connector behind the rear tire of the driver side, on the outside of the frame rail. As shown in the attached photos, an underbody cover will need to be removed…
