Videos
for Ford Excursion Owners
Help Articles
for Ford Excursion Owners
Expert Answers
for Ford Excursion Owners
This all makes perfect sense Clinton, and you gave really good detail. Here's the good news, you can absolutely upgrade from your 13k BTU unit to a 15k BTU unit with no issues. Both sizes use the same standard roof opening, so it’s a…
view full answer...Hello Kyle. I am very sorry but we do not have a Class V hitch for the 2003 Ford Excursion. We do however have a Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2" #C14011 which is a custom fit to your Excursion. This hitch will line up…
view full answer...Our only custom fit trailer hitch receivers we have for your 2000 Ford Excursion are the Curt Class IV #C14011 and Torklift Class V #TLF1006. The Curt has one 2" receiver while the Torklift has two 2" receivers. We do have a Curt Class 5…
view full answer...Hey John, yes the brake controller wiring that comes with the 7-way kit part #22112 that you referenced will work with the Tekonsha Voyager brake controller part #TK26BR as it uses the same connector. Do you have the Voyager already?
view full answer...Thanks for the picture Jim! Yes, you'll definitely need to remove that 7-way and reinstall it. The Curt Hitch item #C14011 is custom fit for a 2000 Ford Excursion and it does not have any pre-drilled holes or slots to attach the 7-way. We did…
view full answer...Hey Martin! Carrier is no longer making RV AC units. Although there were some plug and play replacements available in the past, everything has switched to the new R32 refrigerant following 2025 EPA guidelines. This means a complete system replacement…
view full answer...Hey Joe, The easiest way to install your replacement harness is to unplug one wire at a time and replace it with your new wiring harness. With that being said, I definitely can appreciate just wanting to unplug everything and start fresh. I'm…
view full answer...Yes we have just the replacement gauge you are looking for with the part #AL25195.
view full answer...Hey Jacob, The Replacement Dual Analog Gauge #AL25195 can be used, as long as you have all of the wiring hooked up correctly. I was able to find a wiring diagram for this gauge and I'm attaching that photo to this page for your reference.
view full answer...The air bag kit I recommend going with for your 2003 Ford Excursion is the Firestone Ride-Rite Air Helper Springs #F2251 which don't have the inner bump stops, but that's because they don't need them. Firestone has been in the air bag…
view full answer...In order to choose the best weight distribution hitch, you will first need to know your total tongue weight (TW), which is the tongue weight of your fully loaded and ready to go trailer plus the weight of any cargo behind the rear axle of your tow…
view full answer...Hey Wes, I’d avoid it. All of the battery heaters we carry, such as the 50w #ZE77FR, 80w #ZE87FR, and 160w #ZE27FR Zerostart pads, are not recommended for lithium-ion batteries because they heat too directly on the case. Lithium cells need…
view full answer...



































