Custom Fit 2018 Ford Edge Accessories

There are a few differences between the Curt Hitch #C78KR and the Draw-Tite Hitch #75214 for your 2021 Ford Edge. First off, the Curt offers a 675 pound maximum tongue weight/4,500 maximum gross towing weight while the Draw-Tite has a 600 pound…

The difference you mentioned is the key difference between the hitches you referenced for your 2018 Ford Edge. The #C13234 is a much more visible option than the #C78KR which only has the hitch opening visible below the rear bumper. The #C78KR also…

After looking at the Sea-Doo Move trailer you more than likely will not have enough clearance with the fender if you switch to a 13" wheel and tire. In order to find this out you would need to take some measurements. You would also need to know…

Tekonsha does make a vehicle wiring harness confirmed to fit your 2020 Ford Edge SEL. You will need the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118805. The Tekonsha #118669 you purchased is only confirmed to fit the 2015-2018…

You will need to start with a 4-way (if you do not have one). For that you would want the #118669. I attached an install video that shows this installed in a very similar 2016 Ford Edge as yours. Now if your trailer does not have brakes all you would…

All the 4-way vehicle wiring harnesses like the Curt T-Connector Vehicle Wiring Harness #C56272 that fit your 2018 Ford Edge will require connecting directly to the tail light connectors. If you plan to run your 4-way permanently outside your Edge I…

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

The best hitch for your 2023 Ford Edge is going to be the etrailer Trailer Hitch Receiver item #e34AR. This hitch is custom fit and bolts to your Ford with included hardware. This is a class III hitch with a 2" receiver. It has a 4,000 lbs…

The Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #HM11140484 should definitely not be too short, so if it's not reaching then you either have the wrong harness, or it's the right harness but it arrived…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I recommend replacing your lights with the LED RV Dome Light w/ Switch #RVILL50. These LED lights will outlast and use less power than the florescent tube lights in the Liteco 179 that you currently have. These lights are 15-3/4" long x…

My recommendation is to stay with the load range that your trailers axle is rated for and that matches the tires on your trailer. In this case a load range E trailer tire, like item #AM3H490, is rated for 1,650 lbs, which would be good for a single…