Optronics LED Side Marker Light and Mid-Ship Turn Signal Feature Review Video

We do have some tire chains that will fit your 11-22.5 tires, but none of the Thule chains will fit. You can use any of the following chains: For single wheels (it is permissible to have chains just on one of the wheels on a dually wheel set on each…

Yes, we do offer tire chains for 11Rx22.5 tires. For this, I recommend the Pewag All Square Snow Tire Chains part #PWE2247SC for single tires or part #PWE4247SC for dually tires. These chains have square links so they will do a great job of biting…

Hey Tim, yes you are going to need to cut off the old chain or cut off the loop that is welded to the trailer frame so you can install a new 24 inch safety chain like the part #TCTSCG30-724-03x1. I would cut the chain though so that you can reuse the…

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

For the Pro Series RB2 system and its head, #58333, there are different spring bars you could use. You need to go by the total tongue weight of the set up. This is the tongue weight of the trailer when loaded and ready to tow plus the weight of…

What you are looking for is the snap up handle #RP58162 which we have confirmed with Reese/Pro Series as being the correct handle you'd need. The head and picture you sent in a picture of is the Pro Series RB2 part #58333.

I checked with the manufacturer, the Reese Pro Series RB2 Weight Distribution Head part #58333 works with both round and trunnion style spring bars. The Reese/Pro Series RB2 Weight Distribution System #49568 which is a round bar rated at 600 lbs uses…

There is a solenoid like in your photo, and it is possible that Replacement Solenoid #LC118246 will fix your issue. I'm guessing that when opening and closing, doing so one way is causing more problems than the other. If so, what you can do is…

I've attached the only wiring diagram that Lippert has listed for the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units #LC118246 below to help.

I can give you a list of parts below that will be needed to rewire a trailer which you can then use when combined with the labor rate of the shop to give you an estimate but it can be very hard to estimate the price of said job because the labor…

The wheel retainer ring that is included in certain hub assemblies like the Dexter #8-430-5UC3 that you referenced will be installed on dual wheels when tapered coned lug nuts like #6-109 are used instead of flange wheel nuts. It essentially allows…

I went out to the warehouse and found that the center to center measurements of the holes on the Optronics Door Grab Handle #01180089B are 8-5/16" and 9-1/2". The adjacent holes are about 11/16" apart on center.