Select the correct transmission cooler by determining where there is enough space to mount it. The diagram on the left numbers the best three positions to mount the transmission cooler in order. Transmission coolers are more efficient when they receive maximum air flow. At Position 1, the transmission cooler is 100% efficient. Position 2, between the air conditioning condenser and radiator, is 75% efficient while Position 3, between the radiator and fan, is only 60% efficient. If positions 2 or 3 are used, a larger transmission cooler will be needed to compensate for the loss of cooling power. If this is the case, choose a transmission cooler that is one or two sizes larger.
Tech Tips: Transmission fluid cannot be over-cooled, but it is critical in extreme cold conditions to allow the vehicle to warm up before driving.
Transmission Coolers Specs:
Features:
11" Wide x 8-3/4" tall x 7/8" deep, efficient heat exchanger will prolong the life of your transmission and improve its overall performance. Specifically designed for vehicles with late-model, electronic overdrive transmissions.
More Information >Videos
for Transmission Coolers
Help Articles
for Transmission Coolers
Expert Answers
for Transmission Coolers
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...It&amp…
view full answer...All of the 2015 Honda Pilots would have a hitch installed on them from Honda. So that is one less piece of the puzzle that you would need. Since you wanted to do some towing you might be interested in etrailer ball mount kit #989900. It comes with…
view full answer...It looks like all 2015 Honda Pilots come equipped with a hitch already (save for a select few).…
view full answer...There are 2 different capacities independent of each other though related. Tongue weight is the downward force or weight on the trailer hitch. So it is pushing down at the back of the vehicle. The gross trailer weight is the weight of whatever it…
view full answer...There is not a fuse we carry for the 8000 Series of Fan-Tastic vent. It does use a 4 amp slow blow fuse so to make fuse access simpler you can use In-Line Fuse Holder #C58470-1 and if you need to replace the bow-tie bracket, motor, and blade the…
view full answer...The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached…
view full answer...In regards to your 2013 Chevrolet Silverado, if you will be removing the auxiliary transmission cooler then I recommend using the Derale Series 9000 Plate-Fin Transmission Cooler Kit part #D13614 to replace it. This cooler measures…
view full answer...You can install a stack cooler in your vehicle. The Class ratings are there as a reference point to a hitch Class. For example if someone has a Class III hitch they can look at coolers, see a Class III and say, hey, I have a Class III hitch so this…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...