1994 Suzuki Sidekick Replacement Top

Good question, Chuck! You will not need the Brake Relay #RM-88400 when installing the Roadmaster 4 Diode Wiring Harness #RM-15267 on your 2018 Jeep Wrangler JL Unlimited. This is because the stop light switch circuit on your Jeep JL will go dead…

Hey Neal, we have confirmed with Curt in the past that the front hitch part #C73ZV is confirmed to fit your 2022 Ram 2500 Power Wagon. What are you planning on putting in the front hitch?

Hello Christopher, We do not have the bow system for your 1993 Isuzu Amigo, and that is part of the roof frame. That is required, as well as the factory hardware for a replacement soft top, so if you have that you can use the Pavement Ends Replay…

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

I have another option for you, but the Timbren Heavy-Duty Axle-Less Trailer Suspension - Straight Spindle - Regular Tires - 3,500 lbs #TASR35HDS04 you were looking at actually uses 5200lb hub and drum assemblies and is not available with the 5 on…

Although the #TASR35HDS04 Timbren Axle-Less suspension you'd looked at has a 3500 lb capacity but is compatible with hubs that would have a 5200-7000 lb capacity, depending on which bearing set is used. We don't offer an idler hub compatible…

Whenever you are testing for the cold side of the brake switch you'll want to use a volt meter like #PT89ZR rather than a standard test light, which I assume you are since you gave me the numbers of the read outs. The cold side of the brake…

Since the Patriot #BLU37TR is wireless and portable the installation process is quite simple as compared to other braking systems. The only other electrical component needed is a 12V outlet kit #RM-9332 which provides operating power to the Patriot.…

What braking system are you planning on using? If the system presses the brake pedal of the 2018 Jeep JK Wrangler like most do then yes you do need to use the #RM-88400. The reason for this is so that the stoplights of your Wrangler don't…

The Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit, part #RM-15267, is the best option for you to use to flat tow your 2017 Jeep Wrangler. It will provide a 6-Way wiring harness to the front of your Wrangler that you can connect to the 7-Way…

I have everything that you need to flat-tow a 2019 Ford F-250 which includes tow bar, base plates, wiring harness, and a supplemental braking system if required. I have attached the products I recommend you use below. I do not have an all inclusive…

While we do not have the Blue Ox EZ Light Wiring Harness that you mentioned installing on your Jeep, I was able to locate the installation instructions for the kit. It looks like the converter box that you mentioned is designed to protect the wiring…