Hey Carole, thanks for reaching out! The Swagman Swivel Hitch Extender #S86SR has arms that are about 29-1/2" long. Swagman actually has a dimensional photo that gives more dimensions that you'll ever want that I'm attaching for you to…
Good question, Chuck! You will not need the Brake Relay #RM-88400 when installing the Roadmaster 4 Diode Wiring Harness #RM-15267 on your 2018 Jeep Wrangler JL Unlimited. This is because the stop light switch circuit on your Jeep JL will go dead…
Hello Andrew, Well that sounds like quite the fun trip, what state or states will you be traveling through? You're asking a really important question, especially since you're planning a cross-country trip with about 250 pounds of bikes and…
Hey Neal, we have confirmed with Curt in the past that the front hitch part #C73ZV is confirmed to fit your 2022 Ram 2500 Power Wagon. What are you planning on putting in the front hitch?
Hey Wendell, It sounds like you could have an issue with either the control module, or the motor of those steps. I would lean more towards the control module since that is what the system runs through. It is most likely sending incorrect signals…
Hey Doug! The closest thing we have to what you're asking for is the 1-1/4" to 2" Trailer Hitch Adapter item #e93YR. This has a 5" rise and most likely won't work for your Camry for the same reason what you're asking for…
Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
Hello Christopher, We do not have the bow system for your 1993 Isuzu Amigo, and that is part of the roof frame. That is required, as well as the factory hardware for a replacement soft top, so if you have that you can use the Pavement Ends Replay…
Although the #TASR35HDS04 Timbren Axle-Less suspension you'd looked at has a 3500 lb capacity but is compatible with hubs that would have a 5200-7000 lb capacity, depending on which bearing set is used. We don't offer an idler hub compatible…
I have another option for you, but the Timbren Heavy-Duty Axle-Less Trailer Suspension - Straight Spindle - Regular Tires - 3,500 lbs #TASR35HDS04 you were looking at actually uses 5200lb hub and drum assemblies and is not available with the 5 on…
The front bumper on your 2005 Jeep Wrangler does resemble the Smittybilt XRC. If that is what you have then you actually won't need a base plate kit as you can use D-Ring adapters to flat tow your Wrangler. We have verified this with Smittybilt…
