Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We have a folding trailer tongue hinge that could work for the purpose you describe, as long as your trailer frame isn't constructed of aluminum. You could use the Fulton Fold Away Coupler Hinge, part #FHDPW330300. The hinge kit is…
view full answer...I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
view full answer...The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have…
view full answer...The only way I can recommend a tongue extender for your trailer that has a 3 inch by 3 inch channel is to remove your current coupler, install the hinge kit part #FHDPW330300 in place of it and then install your coupler onto a length of 3 by 3…
view full answer...To install the Fulton Fold-Away Coupler Hinge Kit for 3" x 5" Tongue #FHDPB350101 you will simply need to cut your current trailer tongue so that you have the desired length that is foldable (see attached customer photo). Because of…
view full answer...It sounds like you have a single axle trailer and are curious about whether or not to put the hanger like the part #28-5 or a shackle in front on the trailer frame. We recommend you put the hanger in the front. The force from the bumps in the road…
view full answer...If your 2003 Dodge Ram 2500 has a factory hitch that has an opening that measures 2-1/2 inch by 2-1/2 inches the Curt hitch extender part #C45048 will simply just slide into it. The 2-1/2 inch hitch size is pretty common on newer heavy duty trucks…
view full answer...There are a couple of things that you can do to get more ground clearance for your new trailer. First, if the leaf spring stack is attached under the axle then you could use an over/under conversion kit. If the trailer has a 2-3/8 inch diameter…
view full answer...You can raise your trailer about 2 more inches using the Correct Track Trailer Alignment and 2" Lift Kit - Single Axle #LC87120. Then you can also add longer hangers if you prefer. We do have long hangers like #115919 which are the longest…
view full answer...If your Can Am Commander has a 2 inch hitch the hitch extender that would most likely work best for you would be the #HE18. This product has more than enough capacity for your spreader, but you should note that when you use a hitch extender like…
view full answer...If you have a 2 inch hitch we do not have any solutions for this. If you have a 2-1/2 inch hitch, we don't have 48" but can go 34" with the #RP45292. Depending on how the angle of the ramp changes a super long extension may…
view full answer...It is highly recommended that the spring seat be at minimum tack welded to the axle. There have been issues that have resulted from the seat not be welded to the axle. If you do not have access to a welder, I recommend taking the trailer to a local…
view full answer...Filter Your Search
Contact and Help