Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
When a trailer wheel/tire like the bias ply Kenda #AM30120 shows a weight carrying capacity of 910-lbs, which is for Load Range C, that is for just the one wheel/tire. So, yes, you would double that to determine the total weight capacity of the…
view full answer...Yes, you can replace your weld-on coupler with a bolt-on coupler you will just have to drill the holes The Demco Cast Head Coupler w/ Jack Hole #DM37ZR would be a good replacement. The coupler has a 10,000 pound weight capacity and will fit a 2…
view full answer...Unfortunately the Atwood 85736 cannot be replaced so you'd actually need an entirely new actuator. The closest replacement we have is the Demco Hydraulic Brake Actuator #DM72VR. This actuator has a gross towing weight capacity of 7,000-lbs,…
view full answer...I recommend using Grade 5 1/2" x 4" bolts to install the Demco Channel Tongue Trailer Coupler part #DM12717. These would allow for the full weight capacity of the coupler to be achieved. These can be picked up at most local…
view full answer...When using an idler hub or a hub and drum with brakes on the Timbren Axle-Less Trailer Suspension System, part #ASR2000S02, the difference in the distance from the bracket to the front face of the hub as shown in the attached drawing would be the…
view full answer...After you plug the 4-way in from your 2006 Ford E-350 to the Curt Trailer Connector Adapter #C57102 you will need to run the rest of the wires as follows: The white wire will need to be grounded to a clean metal surface. The blue wire will go to…
view full answer...The mounting holes of the etrailer.com trailer coupler are spaced 3-1/16 inches apart on center. The holes themselves are a 1/2 inch in diameter.
view full answer...The Draw-Tite Class III hitch you'd looked at, part #75676 uses 6 M12 x 1.25 x 40mm (12 mm diameter with a 1.25 thread pitch x 40 mm long) class 10.9 bolts to secure the hitch to the nuts that are welded into the frame of your Lexus RX350. We…
view full answer...To mount the Channel Tongue Trailer Coupler - Trigger Latch - Bolt On #CT-5003-Z, I recommend using 1/2 inch bolts. The higher the grade, the stronger the bolt. I've attached the review video to help as you plan this installation.
view full answer...It looks like you need the part #BD500219. This lynch pin is 3-9/16" overall and has a diameter of .563. Check out the review video I attached as well.
view full answer...Your best route is to replace your entire surge brake assembly as Atwood no longer produces any parts for their brake actuators. The Titan Zinc-Plated Brake Actuator #T47457207K is going to be your best replacement available. It is specific to disc…
view full answer...The best hitch for a 2024 Hyundai Tucson is the etrailer Hitch item #e38KR. This hitch is custom fit and bolts to your Tucson with included hardware. It is a class III hitch with a 2" receiver, that has a 3,500 lbs towing capacity and a 525 lbs…
view full answer...Filter Your Search
Contact and Help