Search: level indicators   >  

I reached out to my contact at TST and confirmed that the TST TPMS - Color Display - Signal Booster - 6 Internal Tire Sensors #TST-507-INT-6-C you were looking at will work perfectly fine with the Counteract Balancing beads you use in your tires.…

Hey Troy, the High Pointe Built-In RV Convection Microwave #HP99ZR does not require outside venting so it would be an easier install like you are looking for.

The High Pointe RV Convection Microwave #HP99ZR has a maximum power input of 1,500 watts in both microwave and convection mode. The 1,000 watt rating is the output cooking power provided in microwave mode.

Yes, the Portable Power Watchdog Surge Protector with Bluetooth - 30 Amp, #HU97FR can be used with generators however, many generators (portable) have a floating ground/neutral; so you will want to determine this with yours as you may need an added…

The Edge Pulsar programmer and monitor part #EP54KR can give you up to an additional 136 horsepower and 291 ft lbs of torque.

While we don't carry the SoftStartUp, we do have the similar SoftStartRV #SSR54FR. Unlike the SoftStartUp, the SoftStartRV installs on your rooftop inline with your A/C, as oppose to inline with your entire RV like the SoftStartUp. The…

I attached a picture of the wiring diagram found on your Dometic Brisk Air AC unit. To install you will remove the white wire coming from the compressor to the run capacitor and connect it to the blue wire on the SoftStartRV. Next take the black wire…

Thank you for providing that picture. In order to install the #SSR54FR on your Dometic AC you will start by removing the white wire coming from the compressor to the run capacitor and connect it to the blue wire on the SoftStartRV. Next, take the…

Dometic water heaters like the Dometic RV Water Heater #AT96121, which is no longer available, do not have anode rods. If your water heater is giving off a bad odor, I recommend sanitizing your entire system including your fresh water tank. What you…

For the etrailer D-Ring Tie Down Anchor #RRING-Q6000 you will need to use the Backing Plate #BP05. This will increase surface area for the bolts used to attach the anchor to your floor giving it additional support. I included a video of the…

For a tie down D-Ring that doesn't have a weld to fail like your current tie-down you'd have to transition to a different design like the etrailer D-Ring Tie Down Anchor #RRING-Q6000. The options we have with the same design that you…

Yes, the Blue Ox Hitch Receiver Immobilizer II #BX88225 that you referenced can be used with a weight distribution shank like what you have.