Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Curt #C13900 is width adjustable, determined by where the bolts are installed in the crossbar of the hitch. If the hitch is assembled in its narrowest orientation as explained on page 3 of the linked instructions, it'll fit on frames that…
view full answer...The Firestone kit, part #F2706, does fit your 2019 Ram 2500 and is going to add support to the rear. With that being said in my opinion it's going to be overkill for your 3,000 pound UTV trailer. This is the Red Label Extreme Duty kit so…
view full answer...The sag you are experiencing when towing with your 2020 Ram 2500 is normal due to the weight that has been added to the rear of your truck, but you definitely want to add rear suspension enhancement to even it out. The reason is, with the sag, the…
view full answer...If you check out the video I attached you can see how 7-way harnesses like the one you referenced disconnect at the rear of them. Right at the 46 second mark you will see the pin that has to get removed.
view full answer...Yes, you can definitely cut out parts of the BedRug Custom Full Truck Bed Liner so that you have access to the puck system for 5th wheel towing with your 2013 Ford F-350. The correct BedRug for your pickup depends on the following specs for your…
view full answer...The Thule Hullavator Pro Kayak Carrier and Lift Assist #TH898 actually comes with the hardware necessary to fit into the T-slot channel on the Malone AirFlow 2 Aero Crossbars 58" #MPG216. You do not need anything else in order to do this.
view full answer...From my understanding you should just need the M6 x 30 Socket Head Cap Screw #TH919063054, the M6 Washer #951061254, and the Square Nut #853-7557 for installing the older Hullavator into the T-Slot of a crossbar system. This stuff should have come…
view full answer...The cannister of the Pace Edwards JackRabbit tonneau covers like the part #311-JED7936 are 9-3/4 inches wide so that is how much bed space you would lose.
view full answer...I would recommend going with the Reese Fifth Wheel Installation Kit, item #RP50064-58, for your 2008 Chevrolet Silverado 2500, because it is the best selling kit, and replacement parts are easily available if needed. We have instructions, see link,…
view full answer...The B&W Ball and Safety Chain Kit #BWGNXA2062 will sit 5-3/4" above the gooseneck ball hole on your 2020 Ram 3500. You will need to add or subtract any difference in the bed height from the top of the bed rails to the top of the gooseneck…
view full answer...There is a 5th wheel wiring harness for your 2020 Chevy Silverado that was designed to fit perfectly in the factory cut out in your truck bed. The harness you need is the Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness #HM54FR. I have…
view full answer...In regards to the installation of a trailer axle like the Trailer Axle with Idler Hubs part #e25GR, you'd simply need to lift the trailer off the ground until the wheels are no longer touching then it's just a matter of removing the u-bolts…
view full answer...Related Searches
Filter Your Search
Contact and Help