Installing The Diamond RV Lighting T5 Bulb Into A Ballast With A Switch
Im not the handiest guy when it comes to electricity so I need some guidance. The directions with the light are very confusing. I have a switch on the fixture. Your video review says to just wire the new LED into the power source, but in...
Stainless Steel T-Strap Hinge for Side and Rear Trailer Doors
Are these hinges stainless steel? | Polar T-Strap Hinge for Side and Rear Trailer Doors # PLR3416 is galvanized (zinc-plated) steel but not stainless steel. The zinc coating helps resist corrosion. For a similar hinge that is stainless steel...
How Much Height Does Fan-Tastic Roof Vent # FV802250 Add to Trailer
Part #FV802250 Ceiling fan. I have this unit in my RV. The thermostat quit working. This appears to be an exact match, with the exception that it appears to not be flush mounted like mine. Can you tell me how tall it is from the mounting plate...
Best Way to Carry Two Electric Bikes on a 2000 Chinook Motorhome
I put a picture of the rear of my 2000 Chinook Concourse 21 ft RV. There is a hitch in rear and I wonder if this rack will work with the rear door. I have 2 E bikes. I am also debating putting a hitch in the front and mounting the rack there....
Winch Mount Recommendation for Superwinch on 2006 Arctic Cat 400
2006 Artic Cat 400 work quad. Any information on installing winch and location of relay on this quad. It looks like it has a factory winch plate, can I use it. | The winch plate you need for your 2006 Arctic Cat 400 is the Bulldog Winch Custom-Fit...
Do Light Strips DI44ZR Just Wire In, And Width & Height of Strip
2 quick questions: 1-Do I need to remove the existing ballast, or do I just connect them up as per the instructions? 2-What is the W and H measurement? I have an older T5 fixture and want to make sure there is adequate room. Thank you | I...
Will T5 LED Light Bulb DI43VR Replace Fluorescent Bulb
I want to replace the existing fluorescent. Currently I have a Philips F8T5 installed. Pin to pin length is 11 7/8. Distance between pins is 1/4. Will this work for me? Also, I have read that some led replacement bulbs can fry the ballast....
Does Bulldog Winch Mounting Plate Fit 2008 Arctic Cat 400 Without Drilling Holes
Will the Bulldog bdw15002 and mounting plate bdw15108 fit on my 2008 arctic cat 400 without drilling any new holes? Thanks. | Yes, so long as your 2008 Arctic Cat 400 is one of the following models, the winch mount will fit without drilling...
Will Trailer Hub and Drum Assembly # AKHD-655-35-EZ-K Fit Lippert Axle
Will this fit a lippert axle | Yes, the Trailer Hub and Drum Assembly # AKHD-655-35-EZ-K that you referenced will fit a 3,500 lb Lippert trailer axle. |
Recommended RV Roof Vent Cover For 2001 Chinook Glacier
I have a 2004 Chinook glacier and I need two vent cover just the out side covers do you have them | We sure do! For your 2001 Chinook Glacier I recommend the MaxxAir Standard RV and Trailer Roof Vent Cover # MA00-933069 which will install over...
Can Front Hitch Installed On Motorhome Carry a Cargo Carrier
I have a 2004 e350 motor-home I installed your front receiver hitch What if any concerns are there putting a cargo rack on the front instead of the rear of the unit? | You'd most likely just need to be aware of the carrier on the front of the...
Recommended RV Air Conditioner System For A 1998 Chinook Concourse Class B Motorhome
I have a 1998 Chinook Concourse and am looking at replacing a Dometic Duo-Therm Penguin. It is attached to a Dometic Dual Zone thermostat. I need to make sure that everything that I buy will directly replace my existing unit with nothing else...
Replacement Winch for 2008 Arctic Cat 400 with Factory Mounting Plate
Im seeking a replacement for a broken Warn 2.5 CI winch that was originally installed on my 2008 Arctic Cat 400. The original winch was built by Warn for Arctic Cat according to a decal. Can you recommend a replacement winch kit and let me know...
Filter Your Search
Contact and Help