Result: step support

If the switches are there, does that mean tat the wiring is there to install electric steps. | It is very likely, but there is really no way to tell without looking behind the switch to ensure wiring connection and then down by the steps to...

| The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000163 only draws 4.8 amps so you can get by with thinner gauge wire like 16 AWG which we sell by the foot with # 16-1-1. | Please...

I talked to the LaSalle, the manufacturer, and they said that you should be fine using the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 18-1/4" Long x 12" Wide Item # 277-000164 between metal and the rubber step tread on a school/commercial bus. |

| The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 has a 4.8 amp rating. | The instructions for this water tank heater advise installing a fuse to protect against an electrical...

To wire the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164, I recommend using the: -Universal-Design Rocker Switch # PK34310. | Do you have an inline switch available? I’m thinking...

We do have the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 available, which does have a built-in thermostat. | Item # 277-000161 Does this self regulate with a built in thermostat,...

I have also attached a helpful article that goes through this step by step that you can check out. | 2007 chev. pickup. I dont have a pigtail on the pickup. Under the frame I have four different plugs, all...

| The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 each pull 4.8 amps so you'd need a switch that can handle at minimum 20 amps if you plan on powering them all off of the single switch. |

This will be the most effective first step to reduce sway but you can still add other aftermarket kits later on if you still find a need. | will this help my Pleasure-Way 2001 Dodge 350 van RV from wandering when passed by...

The use of small ring terminals make make this step a little easier. Keep in mind that the wiring colors that are labeled on the 7 way will not be a color for color match with those on the end loops. | I have a KarKaddy3 tow...

I attached a picture that shows that step of the instructions for this kit. The roller has to be removed so that the spring of the RAS can lay across the leaf spring like it needs to. | I know the standard duty RAS3611 is...

Yes, you can use two of the ThermaHeat RV Holding Tank or Step Heater Pad # 277-000163 connected to your DC fuse panel. | How would I wire the Therma Heat pad to the fuse panel in my RV? I have 2 of the pads...

I am including a link to the instructions on the Hopkins # HM47294 brake controller and a link to a FAQ page that will have a step-by-step instructions on how to wire a brake controller to your vehicle. | I...

I went ahead and attached the steps from the installation manual for attaching the kit with your overland springs. | Hello, I own a 2020 Silverado 3500hd with a 3,700 cargo capacity. My vehicle has two overload leaf springs...

You are probably overloading the circuit with both the sensor and the ThermaHeat RV Holding Tank or Step Heater Pad # 277-000163 on it. | Help! I got the ThermaHeat RV Holding Tank Heater Pad w/ Thermostat...

It is recommended to wire the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 25" Long x 7-1/4" Wide Item # 277-000163 through a switch so you can control the on and off. | If I should wire this...

If you prefer you can attach this lead, using a 40-amp breaker, such as # PK54540, directly to the battery positive terminal. Please refer to step F in the linked article. | How do I remove the fuse box cover in the engine compartment...

I have stepped down from an F-250 to an F-150 2019 Platinum Crew cab with 5.5foot box and noticed a considerable difference when towing my enclosed trailer. | I have stepped down from an F-250 to an F-150 2019 Platinum Crew...

Yes, since the holding tank pads operate on a thermostat and turn on automatically, a different switch makes sense with the ThermaHeat RV Holding Tank or Step Heater Pad with Thermostat # 277-000164 and Elbow Heating Pad # 277-000161. |

On your 1998 Ford E-Series RV, since you have already checked your fuses and relay, the next step to determine why you don't have 12v power to your trailer battery is to check the 1 o'clock pin on your 7-way vehicle side trailer connector. |

I want to install a circuit from my RV to charge/maintain my towed vehicle battery, but unfortunately, the 7 pin connector on my RV is not currently connected to a 12v hot connection. | I want to install a...

What do you I need to make this work. My RV has 4 pin flat. | Custer Wireless LED Tow Bar Light - Weatherproof - Magnetic Base - 23inch Long - 4-Pin Round Item # LIW-LDTL I did not realize this is sold with a 4 pin round connector....

| The first step I would take is to replace the 14 gauge wire for the electric brakes with either 10 or 12 gauge wire. | I installed 2 new magnets on one on each drum , new wire 14 gauge,replaced brake controller.Useing a...

| Yes, I can give you step-by-step instructions to install the Tekonsha P-3 Trailer Brake Controller, part # 90195, in your 2011 GMC Sierra 2500HD. | need to install p3 controller in a 2011 2500hd GMC truck...