Wiring and Spade Connectors for Switch for ThermaHeat RV Holding Tank Step Heater Pad
Updated 09/12/2019 | Published 09/11/2019
Products Featured in This Question
Question:
Please recommend gauge and type of extra wire needed for three pads and 3 elbow joints wired to your recommended rocker switch. I only see black 16 gauge?! Also type of connectors needed to connect extra wire to pads and elbow wires and to connect to the rocker switch. Thanks
asked by: Pamela S
Expert Reply:
The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000163 only draws 4.8 amps so you can get by with thinner gauge wire like 16 AWG which we sell by the foot with # 16-1-1.
For spade connectors to go from the wire to the switch # PK34360 you could then use the # RM-300115-00 and you'd be set.
Product Page this Question was Asked From
ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 25" Long x 7-1/4" Wide
- RV Fresh Water
- Winterize
- Heating Pads
- Holding Tank Heating Pad
- LaSalle Bristol
more information >
Continue Researching
- Q&A: Why Does the RV Holding Tank Heater Have a Separate Ground Wire and Not a 3 Prong Plug?
- Q&A: Will ThermaHeat RV Holding Tank or Step Heater Pad Help With Cold Weather Camping
- Q&A: Heating Pads for 50 Gallon Fresh Water Tank
- Q&A: Does RV Holding Tank Heater # 372HTH-A Have an Adhesive Backing
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: What Is The Quick Connect Size On The WaterPORT Overlander and Weekender RG33PR?
- Q&A: How To Wire In Three Thermat Heat RV Tank And Pipe Heater Pads
- Q&A: Black Single Rocker Switch with On/On Function and Faceplate
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Which RV Propane Tank Size Do I Need?
- Article: Truck Bed Bike Rack Systems
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Gooseneck to 5th Wheel Adapters
- Article: Sidewinder with Rotating Turret for Short Bed Pickups