Result: Step Support

The Flexco Manual Pull-Out Step for RVs - Single - 7" Drop/Rise - 24" Wide - 300lbs Item # SMFP-1100 is the only single step we carry with a bracket width of 25". | need to replace a single...

| RV step installs like the Lippert Kwikee 32 Series Electric Step # LC3722615 you referenced are pretty simple for most mechanics. | Need to know where close to in Sacramento Ca can I get...

Hey Craig, so the Lippert Electric Tread Lite Step for RVs # LC353543 that you referenced was designed for threshold heights that range from 19-1/2 inches to 22-1/2 inches so it could still work for you but that first step might be a little close to the ground. |

There are four mounting supports for each side of the vehicle: the front support, the two center supports and the rear support. | i have a 2004 ford explorer i can not make...

That said, the fit with the kick sensors is tight so there are a few things you need to do during installation to ensure compatibility. The steps labeled 5, 6, and 8 in the instructions below all have notes about installing the hitch on models with kick sensors. |

Apply a good coat of wax on the step bars 2 or 3 times per year. The bars are covered by a limited lifetime warranty. | I have purchased a Ford 2014 Explorer SUV, 4 door Limited series. Will the above part...

If you are planning to do some towing with your Explorer, I have included an article that covers the steps to choosing the correct ball mount for your set-up. | I am considering purchasing the trail hitch #13112...

| Step 8 of the instructions for the etrailer Trailer Hitch Receiver item # e98867 state to torque the M12 hardware to 79 lb-ft and the 1/2" hardware to 110 lb-ft. | What range torque wrench should I purchase for part e98867......

So the fenders, luggage rack and step-thru frame will not be a problem. The rack can support bikes weighing up to 75 lbs apiece, so it's ideal for heavier e-bikes with alternative frames. | I have 2 Velotric...

Another useful item is wheel step # HE4040. It makes loading and unloading the bag easier. | I was looking at the Rightline Cargo Hatch Saddlebag and was wondering what you may have like this but is supported by a receiver...

It's not a long or involved process by any means, it is just an additional step that you'll need to do to tow. One final component that is needed is a charge line to prevent the battery on your Explorer from draining. | What...