Workhorse  x   >   mercury  x   >   !Car  x   >  

I don’t steering shock ,my question is I need to replace front spring because they are bottoming out and I don’t want to use factory air bags I have appx 1in between the stopper needs to be 1 3/4- 4in space ssc-10 or ssc-11 | If you are needing...

I have a Itaska 35a suncruiser workhouse w22 . I need a new steering stabliliser | For a 2005 Workhorse W22 chassis you will need steering stabilizer and mounting kit # RM-RBK13-RSSA. Steering stabilizer # RM-RSSB is just the stabilizer by itself,...

My chassis battery went dead on my coach so I did a parasitic draw test and when I connected my amp meter to the neg, post and neg. cable my coach stairs closed! Amp reading was going from 2 to 14 amps. Unplugged the motor leads from the control...

Do you have a plug and play harness for my RV? 2004 8368MXG Gulf Stream Sun Voyager 8.1 Workhorse W22. I Have the Tekonsha Prodigy III Break controller. I just dont have the wire like I do in my Dodge Ram that is plug and play for my RV. If...

I want to eliminate air bags on 2004 Winnebago 33L p32 8.1 would I use 7200lb | The SuperSprings 5,200-lb SuperCoils Custom Suspension Coils # SSC-10 would be the correct set for your 2004 Winnebago that's built on the Workhorse P32 chassis...

Hello, I have a 2003 Fleetwood Pace Arrow on a workhorse chassis. I need a power gear slide out motor replacement. The original part # is 10106406. Can you tell me the part number to replace the original? Thank You | The Replacement Gear Motor...

looking at the GVCWR on the motorhome it looks like it will be able to tow my trailer, but i cannot find a hitch with an 8000# rating for it. my trailer loaded weighs 7000# | From what I could find, your 2004 Safari Simba 34SBD will be rated...

I need a dual steering wheel stabilizer for a 2006 four winds Magellan | Hey Susan, the correct steering stabilizer for your 2006 Four Winds Magellan is the Roadmaster Exact Center part # RM32RR. |

What is the max amp hrs. Can I have for a 3000 w. Inverter? | A 3,000 watt inverter like the # 34278157 is rated for 250 amps at 12 volts in output. |

Hi I just want to know if the capaciter as the same fonction of a soft start. Can i use 2 furion on a 30 amp circuit? Thank you | The start capacitor # FR45FR is designed to store energy that will allow you to start your AC unit when there...

Does the 1109-200 fit this motorhome? I know the spreader bar does not fit, and the sway bar 1109-116 does not fit. | Yes, the Roadmaster Sway Bar kit part # RM-1109-200 would fit your 2002 Winnebago Sightseer P32. Since the # RM-1109-116 does...

I need to have over 20ft of Gas line from my Propane on drivers side, just behind driver, to the opposite side of the Class A, 12ft will just get me over to the other side, but the grill needs to be a little further away from the Motorhome....

How much height do snap pads add to the lift ? Will they take the wheels off the ground when the jacks are fully extended ? | The bottom portion of the SnapPad Jack Pads # SP54FR2 are approximately 1" thick but they are not meant to lift your...

I have already installed the steering stabilizer on my 2007 workhorse w22 motorhome. Will the anti sway bar add additional stabilization when installed. | The Roadmaster Reflex Steering Stabilizer # RM-RBK13-RSSA will provide you with some...

I am looking for a steering stabilizer kit for my 2007 Itasca Impulse 29T with a Chevy 300 hp v8 option. What do I need? | The correct steering stabilizer for your Workhorse P3500-based motor home that has the OEM dampener is Roadmaster's #...

looking for a rack that holds 3 bikes prefer ably 4 which 2 are electric townie go which would towed without battery pack any suggestion Or do you think this rack Is option also using behind motorhome. | There are only certain bike carriers...

Where Does a Brake Controller Plug Into on a 2003 Holiday Rambler on a workhorse chassis? I have the 7 pin plug on the rear next to the hitch. | I don't believe there is a brake controller port on a Holiday Rambler even if it comes with a factory...

I bought two valves from you at the beginning of march. 3inch and 1-1/2 now that the motor home is out of storage I went to start replacement of the valves. I took out the 1-1/2 first I found out that the Lasalle bolt pattern is different...

Will the rm-rsscp30 fit my 1996 Winnebago brave? The one on there now looks just like this just minus the spring. Thanks for your time! | The steering stabilizer that you need is Roadmaster Reflex Steering Stabilizer with Mounting Brackets for...

Does this part fit all the workhorse chassis w-20, w-22, and w-24 ? | The Roadmaster Steering Stabilizer part # RM-RBK13-RSSA does fit the W20, W22, and W24 Workhorse chassis like you asked about. |

I need help finding the correct model number of a stabilizer spring. It is a Safari Trek 26 foot RV. It is gasoline engine. 8.1 Liter. It is a workhorse. | The correct steering stabilizer for a 2002 Safari Trek 26 Motorhome on Workhorse P Series...

Mfr. said a Snap Pad Prime 4 pack was needed which is P/N PRSP4. I have a Class A Winnebago Workhorse Sightseer WPD26P with a Kwikee Level Best Leveling System On your site I see P/N SP64 FR4 listed for 10 Rounds Pads. Nothing says Snap...

I have 25-3/4, 4 leaf on my 5th wheel, with 4.4k axles, and 013-010-04 equalizer. Axles are 35inch centers, hangers are 29-1/2inch centers. Can I install 26, 6 leaf springs for a 4500# axle, or will I have to change the equalizer. My trailer...

I am about to install my Airlift 1000s in my 2004 Workhorse P32 chassis. Would a set of the 1000 HDs fit, and would there be any noticeable difference between the 1000s and the 1000 HDs? | The difference would be capacity and you would notice...