Low Profile Cargo Box and Roof Rack for my 2008 Lexus RX400h
Hi, I need a crossbar + roofbox to be under 7 feet for my 08 Lexus RX400h with side rails. From my calculations the crossbar and roofbox should be 17inch or less. Im looking at the Inno Shadow 16 + Inno square bars. Will this work? | The...
Air Lift 1000 Air Helper Springs Recommendation for a 2004 Mercury Sable Sedan
1. How do you AIR up the air lift suspension ? 2. Do you have to have a compressor and tank attached to this system at all times ? 3. Does this stop the rear from flexing when loaded down in the trunk and with people ? 4. Is this an EXACT...
Will the C12232 Class III Trailer Hitch Fit with Factory Dual-exhaust on a 1998 Mercury Sable
Will this hitch be compatible with my 1998 Sable dual-exhaust model? None of the pictures or installation instructions mention this specific model. | I spoke with my contact at the manufacturer to make sure there were no issues with the factory...
Trailer Hitch Receiver to Fit a 1995 Mercury Sable that Doesnt Require Drilling
Does this hitch require drilling to install on a 1995 Mercury Sable 4 door sedan? | The Curt trailer hitch receiver that fits the 1995 Mercury Sable is part # C12232 and it does not require any drilling to install it. The hitch you looked at,...
Can a Canoe be Carried on the Roof of a 1998 Honda Prelude
How can i safely transport a canoe on the roof of my 1998 Honda Prelude? | To carry a canoe on a vehicle that does not have roof rack you can use a universal foam block carrier, # RL100K10. The roof on a 1998 Honda Prelude is pretty short and...
Fit of Thule OutWay TH45JV on 2007 Lexus RX400h
Have a factory installed spoiler on the back of the 400h hatch, above the rear window. Wondering if it is safe to hook the thule outway 2 onto it or will the weight of the bikes rip the spoiler off the vehicle? | In many cases, having a solid...
How High Will CE Smith 13 Inch Bolster Bracket Sit Above 3 Inch Crossmember
I am going to be replacing rollers with bunks on my ez loader trailer. The boat will need to sit rather high due to the width as the boat will need to be above the wheel fenders. For the two inside bunks, the boat will need to be at least...
Will The Curt Trailer Hitch Receiver C12232 Fit a 2001 Mercury Sable Station Wagon?
Will #C12232 fit a 2001 Sable Station Wagon? I don’t see anything about wagons. | Yes, the Curt Trailer Hitch Receiver # C12232 is compatible with your 2001 Mercury Sable station wagon as well as the sedans. This will only fit on models with...
Trailer Hitch and Wiring for a 2008 Lexus RX 400h
Will this hitch fit a 2008 Lexus RX400H? | Yes, Curt trailer hitch # 13530 fits your 2008 Lexus RX 400h. I have linked a video showing an example installation for you. If you plan on doing some towing I recommend etrailer ball mount kit # 989900....
Availability of Roof Rack for a 1981 Honda Prelude
I am looking for a rack set up for my 1981 Honda Prelude | We do have a roof rack option for your 1981 Honda Prelude! The only roof rack that will fit your Prelude is the SeaSucker Roof Rack which comes with 48" Monkey Bars and 6 vacuum cups,...
Does Installing Trailer Wiring Harness for the 2006 Lexus RX400H Require a Battery Connection
Does the code 119147KIT trailer wiring harness for a 2006 Lexus RX400H require a wire be run from the rear of the vehicle to the battery? | Yes. The # C59496 trailer wiring harness for the 2006 Lexus RX400H does require a separate power wire...
Kayak Load Assist Options for a Vehicle with Factory Roof Rack
Will the Rhino-Rack Universal Load Assist Fit Factory Crossbars on a 2008 Lexus RX400h | It sounds like you need help loading a kayak(s) on your 2008 Lexus RX 400h with a factory roof rack. If that is the case then I do have an option for you...
Replacement Installation Hardware For Trailer Hitch For 2006 Lexus RX 400h
Have 2006 lexus rx400 hitch. I need the bolts that go with this hitch. Do you sell just the bolts and washers? How much. | We sell a replacement installation kit for the trailer hitches we offer. For your RX 400h I found the Draw-Tite #...
2006 Lexus RX400h Hitch Recommendation
I have a 2006 lexus rx400h and I need a hitch setup for a motorcycle carrier.. My motorcycle suzuki bandit 1200 weighs about 500lbs.. This motorcycle carrier states that it works with a 3inch class 3/4 receiver.. I believe that this carrier...
Tips on Finding the Brake Light Wire on Brake Switch for Brake Controller Install, 2007 Lexus RX400H
Hi! I purchased Prodigy brake controller and the wiring kit for a 7 pole braking package a few weeks ago. Wired it all up but can't figure which of the four wires coming off the brake pedal is the correct wire to connect to. | Finding the correct...
Will Thule Camber Bike Rack Clear the Rear Bumper on a 2008 Lexus RX 400h with Curt Trailer Hitch
Hello, I was wondering if this would clear the rear bumper of a 2008 Lexus RX400H with a Curt Trailer Hitch? | The Thule Camber 2 bike rack # TH9058 measures 5-3/4 inches from the center of the hitch pin hole to the foot of the carrier and...
2006 Lexus RX400h Trailer Wiring and Hitch Recommendations
Will this kit 13530 and C59496 work with 4 wheel drive and the LED tail lights | Yes, the Vehicle Wiring Harness, part # C59496, will work with the LED lights that your 2006 Lexus RX400h has. Yes, the Curt Trailer Hitch Receiver - Custom Fit...
Locating Cold Side of Brake Stoplight Switch to Install Brake Controller on 2007 Lexus RX 400h
Cant find the brake wire to tie the red lead from an Activator 4-wire brake controller. There is a 4-wire connector on the right side of the brake pedal, but when disconnected the brake light still operated. Where can I find the correct wire...
Replacement Thule Square Crossbar For My Roof Rack
I have an Lexus Rx 400h 2007 with a Thule Roof rack. The crossbars are rusted through.....they are rectangular...not square in their cross-section. They are 52 inches across in endcaps. Can I just get the bars as a replacement part? The rest...
Will Trailer Wiring Harness # C55375 Work with a Wishbone Style 4-Way Trailer Connector
My OLD ...18 or so year old trailer has a harness end with 5 wires but going to 4 pins. Will that work with this wiring harness and if not which one will?......Thanks #C55375.....Simple lite duty trailer with 2 combination lights | What...
Can a Trailer Hitch Be Installed on a 1997 Mercury Sable by a Mechanic
The cost and can a machanic install it. Weight capacity approximately. 3500 pounds. | I recommend the Curt Class II 1-1/4 Inch Hitch, part # C12232, for your 1997 Mercury Sable. This hitch has a maximum gross trailer weight capacity of 3,500...
Should Rusted Trailer Hitch Receiver be Replaced
I installed one of these Curt Trailer hitches on my 1997 Sable Station wagon and it is now so rusty I am concerned about safety. Is there a way to test it to see if it is still safe to use? | The Curt trailer hitch receiver for your 1997 Mercury...
Higher Capacity 24-5/8 Inch Long Slipper Spring
Hello, I recently received and installed your leaf springs SP-177275 on a chassis for a tear trailer Im building. The shell is feeling heavier that what I had in mind, and I worry that these springs will be overwhelmed. Is there a heavier spring...
Troubleshooting Tail Lights on 2008 Mercury Sable Not Working With Curt T-Connector Installed
Vehicle: 2008 Mercury Sable I installed the custom wiring harness on my Sable this evening and thought it was super easy. I verified that the harness with the yellow wire is on the driver side. And I pushed in all the connectors until they...
Filter Your Search
Contact and Help