Converter For Motorhome With Separate Turn/Brake Signals to Combined Towed Vehicle Signals
I have a 2008 Navion IQ on a 2007 Sprinter Chassis with the Winnebago installed 6 pin round trailer adapter, which has separate circuits for turn signals and brakes. I want to convert this for a tow vehicle with 4 pins. Do you have a solution...
Replacement Heavy Duty Motor For Landing Gear On 2010 Keystone Raptor Toy Hauler
Need new heavy duty gear box for electric landing gear. What part number do I need | Your Raptor Toy Hauler likely has a landing gear setup similar to the one you were looking at: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000...
Can I Just Use 1 Latch to Secure MORryde StepAbove RV Steps Inside Camper
MORryde steps and screen door The steps have a latch on the right side. The screen door pinches tight on the latch and wont close. Can I cut out the screen door frame around this area? Remove the right side latch and have the steps not fall...
How to Determine Landing Gear for 2010 Keystone Raptor Trailer
I have a 2010 Keystone Raptor RP3812S10 that i need the front landing gears with motor? | To determine the correct replacement landing gear, you will need to measure the mounting brackets on your trailer from the underside of the top bracket...
Kwikee Steps On Itasca Navion IQ Will Not Stop Once Retracted
2009 Itasca Navion IQ Two problems noted on my last RV trip. First symptom, steps didnt always auto retract. Second, step motor continues to run when the steps are fully retracted after closing the door. I assume its the controller. On...
What E-Bike Carrier Do You Recommend For 2013 Itasca Navion iQ Motorhome And A Toyota 4Runner
Mark S answered my previous question but a follow- up, please. I think the Yakima will be too heavy for me to move between my vehicles. Is there a lighter weight carrier available? Maybe Saris Superclamp HD which I think is out of stock everywhere??...
Bike Rack for E-Bikes With Fenders & Step-Through Frame on Motorhome
I am trying to make the right decision regarding a back rack for our 2 Blix Vika folding bikes. Our RV has a rear slide out so I would like a rack that tilts. The videos I see for Swagman or KUAT racks show the locking system attaching to...
Determining The Pin Box Bolt Pattern On A 2013 Keystone Raptor Toy Hauler
Are the king pin plates all the same dimensions and what are the measurements? | Dimensions on most pin boxes are not the same, with the most important differential being the bolt pattern. Your pin box should have sticker on it either on the...
Landing Gear Recommendation For 2010 Keystone Raptor Toy Hauler
What it the weight for the front lift on a keystone raptor? We are replacing our landing gear and want to make sure we get the right weight Jacks. | While I do not have any way of knowing what your 2010 Keystone Raptor Toy Hauler's pin weight...
Closest Replacement For A Greystone F2611E Fireplace
Will the GR 54 FR replace the F2611E and fit in the same opening. | The closest fireplace that we offer to replace your older Greystone F26111E fireplace is the: -Greystone 26" Electric Fireplace with Crystals # 324-000068. This fireplace...
Will the Gustafson RV Puck Light - 4-1/2" # 277-000344 Fit My 2013 Itasca Navion IQ
Need 41/4 wide base overall 41/2 metal with 3 screw holes it is 11/4 depth. Can you help? | I spoke to my contact at LaSalle Bristol and he confirmed the Gustafson RV Puck Light - 4-1/2" - Recessed - 4 Watt # 277-000344 will be a replacement...
E-Bike Carrier For 2013 Itasca Navion iQ Motorhome And A Toyota 4Runner
Can the Door County model be used with a small motorhome as well as an SUV? I will be moving the carrier between two vehicles, a 4Runner and a 25.5’ Itasca Navion. I love that it is on wheels - how high must it be lifted to install on a different...
Filter Your Search
Contact and Help