Jay Feather Travel Trailer  x   >   !Aurora  x   >   Expedition  x   >   1998  x   >  

I just purchased a 98 ford expedition with a draw-tite activator on it. I dont do any type of towing. so where should I position the slide button, so it wont cause me a braking problem ? tthanks |...

Hello Can you tell me if the Westin 1998 Ford Expedition Westin Molded, Lighted Running Boards w/ Custom Installation Kit - 6inch Wide - Black, Code: 27-0015-1815 are: A direct replacement for factory installed lighted running boards for...

I do not know if I have a harness presently on my motorhome. There is a 4 pin connector installed to go to the trailer harness but dont work. I cant get any electrical current to the 4 pin connector ? | I would first spend a few minutes trying...

I want to connect a 7 pin to my 98 Ford Expedition. I found the connector under the dash, next to the computer diagnostic port. Where underneath the rear of the vehicle would I find the connection for the 7 pin? Thanks | There are three different...

What would you recommend for a 1989 ford expedition 5.4l | You typed 1989 Ford Expedition but the first model year was a 1997 so I assume you meant 1998. Which is good because there are programmer options for the 1998 Ford Expedition. For...

I am looking to purchase a brake control for my RV setup. I own a 1998 Ford Expedition 5.4 V-8. It came with the trailer tow package, so it has the plug under the dash. I tow a 2006 K-Z JAG 20J 20foot trailer approx 3,500lbs. Can you recommend...

I have bull bar Westin bot not have The mounting hardware for ford Expedition 1998 I need mounting bracket | The Westin Bull Bars and their mounting kits are both made to fit specific vehicles. If the bull bar you have is either part # 32-0245...

Hello, When it says 2inch hitch does that mean inside opening of hitch is 2inch to receive a bike rack or motorcycle carrier ? Curt states load must be supported ? Do they mean tie down web belts to hold load or support for the carrier ? If...

Im looking to buy a front receiver hitch foe my 98 ford expedition 4 wheel drive with factory tow hooks. you have 2 models, a Curt and a Drawtite. in your opinion what one is the best. I intend to use it for a snow plow. Thanks for your...

I plan to install a brake controller on a 1998 Ford Expedition with a tow package and a 4 pole trailer connector. I intend to purchase the following items for the installation: Item nos. 3035-P, 37185 and the 90885 controller. Is there anything...

where is the fuse location for my 1998 ford expedition tox package plug. nothing is working | I pulled up a picture of a fuse box of a 1998 Ford Expedition and it looks like position 1 is the trailer tow running lamp relay and back up light...

I have a 1998 Ford expedition without factory trailer tow. I have a aftermarket hitch with a functional 4 way flat plug. I also have a brake controller. I have a circuit tester so do not need that to be included but would like a bracket to mount...

I was told this chip would work for my 1998 ford expedition v-8 5.4 l triton is this true... | The Edge Products Evolution CTS3 Programmer/Monitor, part # EP49YR is not compatible with your 1998 Ford Expedition. I have confirmed this through...

will the part #31049 fit the 31 3/4 inch wide with 3inch spaced holes to anchor where the tow hooks go? | The Curt Front Mount Trailer Hitch Receiver part # 31049 is a confirmed fit for a 1998 Ford Expedition 4WD with factory tow hooks. It mounts...

Will these fit out Eddie Bauer 1998 expedition? It have the turn signals in the mirrors ! | We have not tested the Custom Towing Mirrors, # CTM2300, on a 1998 Ford Expedition Eddie Bauer Edition with turn signals in the mirror. I made a call...

I have a 98 Ford expedition xlt 4x4 with 17inch tires. Is there a class iv hitch I can put on it. I plan on hauling a 6x10 dual axle dump trailer. | The highest capacity hitch available for the 1998 Expedition is the Curt # C13049. The hitch...

1998 ford expedition wiring harness for prodigy brake controller | The correct Brake Controller Wiring Adapter for your 1998 Expedition would be part # 3035-P. If your Expedition has the factory equipped 7-way trailer connector as most do,...

Bull bar brackets for 98 ford expedition? | If you have the Westin Bull Bar # 32-0245 or # 32-0240, then you will want the Replacement Bracket Kit for Westin Bull Bar 32-0240 # 32-024PK. Bull Bars are not a universal fit, so you will need to...

Does it fit 1998 Ford Expedition? | The Rooftop Bike Carrier, # S64720, will fit on Thule, Yakima, and most factory roof rack load bars that run side to side on the top of the vehicle. If you do not have a factory roof rack you can add a roof...

what key locks are for the Sweetroll kayak carrier rear loading Y04074 | The Yakima Sweetroll Kayak Carrier # Y04074 does not come with lock cores but you can add them with the Yakima Same Key System (SKS) Lock Cores # Y07204 (pack of 4). If...

1998 ford expedition. Has wire from factory for illumination. Where do I connect to on controller? Or leave it off. | The illumination wire on your 1998 Ford Expedition will not be used with a brake controller such as # 39510 (or any of the...