Delano Motorhome x > !Atlas Travel Trailer x > Canyon Star Motorhome x >

Rear Suspension Enhancement Recommendation for 2012 Newmar Canyon Star 3642

I have a 2012 Newmar Canyon Star 3642 that sits lower on the passenger side due to factory installed items like gallery/refrigerator/water storage/gray water/clothes closet. When it was under warranty Ford said they would not do anything as...

Receiver Hitch For 2014 Newmar Canyon Star Motorhome At Least 6,000 lb. GTW

I have a 2014 Newmar with a 6000 lbs tow limit. The newmar came with hitch with a 5000 lbs. I would like to change the hitch out to one that is at least 6000 lbs tow rating. Do y’all offer one? | The Curt Adjustable Trailer Hitch Receiver, Class...

Roadmaster Steering Stabilizer Shock Installation Orientation

Installation instructions are not very clear. Which end attaches to the chassis mount and which end attaches to the tie-rod bracket? | I reached out to my tech contact at Roadmaster and the shock installation of your Steering Stabilizer #...

Magnetic Door Switch Works Opposite Of What It Is Supposed To

I have a 2011 Newmar Bay Star RV with electric steps. The label on the step frame says Coach Step DBL-STANDARD and LCI Model # 171317. The control module is LCI-164889 and motor LCI-163669 was replaced with 300-1406. I have found conflicting...

Why Do Some Kitcken Sinks Not Have Holes for the Faucet

25x17 off set white kitchen sink That is the correct size I need but my old sink has the holes for the faucet. Where are the holes for the faucet on the white sink | Some RV sinks include holes in them while others are designed for the faucet...

Determining The Correct Replacement Electric Steps For A 2008 Newmar Canyon Star Motorhome

2008 Newmar Canyon Star 3205 rv replacement electric steps | To determine the correct replacement electric RV steps for your 2008 Newmar Canyon Star 3205 Motorhome you'll need to take a few measurements first. You'll need to measure the mounting...

Replacement Parts For The Lippert 171317 Electric RV Steps

I have a 2011 Newmar RV with electric steps LCI#171317. I’m trying to troubleshoot. I have a new motor and control module. I’m looking for install manual, as I need to trace my wiring harness. I’m not trying to replace the step assembly. Help?...

Determining The Correct Size Landing Gear SnapPad Size

I have newmar 2017 canyon star what snap pads should I order | To determine which SnapPad's are right for your 2017 Newmar Canyon Star Motorhome, you'll to first measure the diameter of landing gear foot; be sure to include the 'lip" in this...

Replacement Lens for Petersen Clearance Side Marker Trailer Light With Reflex Dimensions

What are the masurments on this lense | I went out to our warehouse and measured the Replacement Lens for Petersen Clearance Side Marker Trailer Light with Reflex # PE95ZR, and measured 3-3/16" long, 1-5/8" wide, and 2-3/4" on center between...

Seat Cover For RV Captains Seats in a 2013 Newmar Canyon Star Motorhome

Please help me find a replacement drivers/passenger seat cover for 2013 Newmar Canyon Star. Any suggestions? | At this time the Classic Accessories RV Captain Seat Cover # CA80112 is the only seat cover we carry. This cover is designed to fit...

Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710

We have a 2016 Newmar canyon star 3710. It has the equalizer leveling system. The jack feet are octagon shape. They measure 10inch from end to end on outside. Inside round hole is 8 3/4 to 9. Which model number pad do I need. Thank you | For...

Will Furnace & Heat Strip Work With ACDOM150

We bought a Acdom 150 15K unit to replace my old dometic unit in my Newmar. Will I be able to run seperate furnace and heat strips through the new wall thermostat? thx | The Advent Air Replacement RV Air Conditioner for Dometic Setup # ACDOM150...

How To Carry Bike Rack and Cargo Carrier Together On Back of Motorhome

Hello, I was hoping you can help me figure out what dual hitch receiver adapter I need. The goal would be to have some sort of dual hitch that I can put into my RV hitch receiver so that I can utilize the cargo carrier and bag AND the bike...

Bike Rack Compatibility with Motorhome While Flat Towing a 2015 Kia Soul

S44FR I would like to use this bike rack in a dual receiver hitch on my Newmar motor home, while flat towing a 2015 Kia Soul. I currently flat tow the Soul with a Roadmaster tow bar and a 2inch receiver. Will this bike rack contact the towed...

Recommended Suspension Upgrade for 2011 Newmar Canyon Star 3920

Any recommendations on an upgrade to suspension to help with sway on 2011 Newmar Canyon Star 3920? | I recommend adding front and rear SumoSprings to your RV. For the front kit you would need # SSF-173-40-2 and for the rear use # SSR-187-54-1....

Correct Replacement Control Panel for a Lippert 4-Point Leveling System On a 2021 Thor Delano

Hi, did this touch pad can replace this one Item # 175225 on my thor delano 2021, thank you | The Replacement Touch Pad Control Panel for Lippert Power Gear Hydraulic RV Leveling System # LC58CJ is the correct replacement for the Lippert Power...

Best Ways to Improve Ride Performance for 2011 Newmar Canyon Star 3920 Toy Hauler

Trying to smooth out our harsh ride when pot holes or rough roads are involved and reduce sway on our 2011 Newmar Canyon Star 3920 Toy Hauler. I have already installed oversized front sway bar and new Bilstien shocks. The front shocks are less...

Correct Snap Pads for Newmar Canyon Star Motorhome

Snap Pad. I have a 2016 Newmar Canyon Star with Equalizer leveling system. Which Snap Pad will fit my coach? | I recommend measuring the feet on your leveling system and noting the shape of the pad. That said, it should be 9" round pads and...

Storage Cover Recommendation for 2021 Thor Delano 24TT Motorhome with Rear Ladder

Hi, I have the 2021 Delano 24 TT with a ladder on the back. Will this cover accommodate the additional length of the ladder? | Your 2021 Thor Delano 24TT Motorhome should measure 24-3/4' long so since the Adco Olefin HD RV Cover for Class C...

How To Remove Motor on Kwikee 24/25 Series Electric Steps

I’m trying to replace the motor for my steps. I know it’s an easy process normally but my issue is I can’t remove the screws/bolts holding the motor to the gear plate. One bolt has a nut that I could reach and remove, so that one was not a problem....