!Liberty Travel Trailer  x   >   !AirBedz  x   >   !SeaSucker  x   >   CTEK Power Inc  x   >  

Hello. I have a 8x16 enclosed trailer. I would like to hppk up a battery and run a power inverter to run tv,stereo,computer etc. I was planning on using a 1000w inverter. I know I need a deep cycle battery and was planning on the battery being...

Could the CTEK Indicator panel be installed in the outside wall of my horse trailer so that I see it as I open the tack room door and so that it is easy to plug in the CTEK charger from the outside of the trailer? THANKS | The CTEK Battery-Health...

Im building a tear trailer and trying to figure out the best setup for my trailer battery. When I installed my 7-way plug in my vehicle I replaced the standard 12v wire with an 8ga. wire that runs from my battery, through a solenoid, to the...

I have a dump trailer. Can I mount the charger inside the battery/pump box on the trailer. Is it weather resistant enough to survive this environment? | The CTEK MULTI US Universal 12-Volt Battery Charger # CTEK56353 is approved for indoor and...

Do you have a replacement battery for this? I stored it away for 6 months full but went dead and will now not hold a charge. I assume it is not supposed to do that. And we are using our decent sized charger for it. What is the proper charger...

Got a brand new 3500 lb electric jack hooked it up and does not work brand new 12 v battery | An electric trailer tongue jack like # EJ-3520-BBX requires both a well-charged battery of the necessary current capacity and very solid wiring connections,...

Im designing an elevator/man cage that I need to lift vertically, that also has a hand crank for use during power outages. Say 2000 lbs +/- Any suggestions? | This is a unique question with a couple of different variables. That is a lot of...

We currently have a small battery with charger and light to indicate power for our breakaway switch. We also have a large sorry dont know the exact size, lets say standard RV battery deep cycle battery for running our electric jack and lights...

I have an enclosed trailer with interior lights. These lights are powered when plugged into my truck. I would like to use my interior lights where I dont have to plug into my truck 4 way plug in. Can I do this and what would l need to just run...

If I have two 6 volt batteries wired in series will the 12 volt Repair mode operate properly or will that mode only work with a single 12 volt battery? | Technically, the CTEK MULTI US 7002 12-Volt Universal Battery Charger w/ Pulse Maintenance...

Saw Redarc In-Vehicle BCDC Battery Charger was excited, but I thought it was an AC battery charges that I could mount under the hood. My 2001 F350s battery goes dead if it sits too long in the cold. Thought a slow charger run in parallel with...

Electric jack won’t extend or retract but light works | Your power issue could be due to one or more of a number of potential causes. These could include loose/corroded battery cables, batteries that need a good long charge with an AC-powered...

I tow a Honda CRV with a Winnebago Aspect. Have a RoadMaster Invisibrake. Looking for the proper trickle charge system to install with this to keep CRV battery from going dead. Thanks | We have the part # RM-156-25 which allows you to charge...

I have. 2015 Ford Transit 150 with the stock alternator and one 60 A customer connection point. I plan to wire four 6v, 225 Ah AGM deep cycle batteries in series and parallel to achieve a 12v system with 450Ah. The batteries have a recommended...

hi, i am asking is there a wire harness after market kit that will adapt from the chev truck to the 7 pin on my 09 hardtop that has a battery on its hitch? under the inside bumper there is a cross rail with 4 wire plugs connected to a flat plate,...

I saw your diagram on how to wire two 12 VDC batteries together in parallel and keep 12 VDC. Three questions on that.... 1. Does it effect in any way a boat motor charging both batteries versus just the one it charged while running before...

I agree with you about wiring the electric jack through a trailer mounted battery, but could you please go a little further into it. If you let the BATT+ wire in the 7-way factory installed trailer harness feed the trailer battery, youll be...

Hi I am going to hook up a winch in my back yard to get my 7 bye 5 trailer up and down my driveway so the winch will not be connected to any car or anything like that just running of a batterie what would be the best batterie to use and how...

Im interested in the Tekonsha Prodigy P3 Trailer Brake Controller for use in two vehicles I have. It will be used primarily with a 1965 F100 which does not currently have any trailer tight wiring. Its an old simple four wire tail light system...

Does plugging into 110 v charge the trailer battery or do I need a charger? | You will need to use a battery charger such as the CTEK MULTI US 7002 12-Volt Universal Battery Charger w/ Pulse Maintenance and Backup Power # CTEK56353. The reason...

I am having a tear camper trailer built, and would like to add a CTEK battery charger so that my trailers battery will charge while we are towing. I see different CTEK battery chargers, of considerably different prices. Which CTEK charger...

I have a 2013 BMW 335i, 2016 BMW M235IX and 2006 Porsche Carrera 2S. Porsche is driven summers only and not daily drivers like BMWs Looking at CTEK mus 4.3. I currently use a Battery Plus maintainer on the P car via the cigarette plug socket...

I have a 18ft flat car hauler that came with a small break-away battery and charger. I have since replaced the breakaway battery with a full size deep cycle battery since the trailer now has a large electric winch, flood lights and 110v inverter....

Looking to see if this Ctek 7002 would be a good charger/maintainer for my 12V deep cycle battery for my travel trailer. Looking for something I can plug in and forget about. Would i need to use the snowflake mode since I have a deep cycle battery?...