Replacement For Dometic Air Conditioner For RV
I own a 2011 Newmar Dutchstar 4344. I have 3 Dometic AC units model 651516.301JO photo attached. Do you have offer a replacement unit to fit these units? I understand I may also need a new thermostat. Any assistance is greatly appreciated....
Adding Internet Service To A 2008 Newmar Canyon Stat Motorhome
I looking for RV devices or antenna that extends long searches for internet, even in boondocking areas in the mountains Do I also need a router? I have a Winegard on my roof but we bought our 2008Newman Canyon Star used so we dont know if it...
What Front Mount Hitch Options do I Have for my Newmar Canyon Star on a Ford F-53 Chassis
Looking for a front mount 2x2 reciever hitch for the front of my f53 Ford chassis motorhome. Its a 2012 newmar canyon star coach. Matter fact I think the chassis is 2011 but the coach is 2012. Let me know what you recommend | I may have a...
Magnetic Door Switch Works Opposite Of What It Is Supposed To
I have a 2011 Newmar Bay Star RV with electric steps. The label on the step frame says Coach Step DBL-STANDARD and LCI Model # 171317. The control module is LCI-164889 and motor LCI-163669 was replaced with 300-1406. I have found conflicting...
Adapter Needed For Furrion RV AC Unit To Dometic Interior AC System
Got a new furrion to replace a domestic that is hard wired so what do I need to connect the new one? | If you purchased the Furrion Chill Replacement RV Air Conditioner for Dometic Brisk Setup - 15,000 Btu # FR42PV it will come with an adapter...
Trailer Hitch Fit for 1995 Pontiac Trans Am
Ive read conflicting answers here, about Firebird vs. Trans Am...I have a 95 TA think the rear bumper is the same from 1993 thru 2002 and wish to install a hitch...Is the dual exhaust a problem because of the muffler, or the bumper...? | The...
Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710
We have a 2016 Newmar canyon star 3710. It has the equalizer leveling system. The jack feet are octagon shape. They measure 10inch from end to end on outside. Inside round hole is 8 3/4 to 9. Which model number pad do I need. Thank you | For...
Power Gear Motor Replacement for # 1010002306 Slide Out
This is the motor that raises and lowers the head of the bed. What is the replacement part for it? | I checked with Lippert and the correct part you need is the # LC58FR. |
Replacement Fan Motor Assembly For a Fantastic Vent Model 6300 Roof Vent
Need replacement fan motor for Model 6300, w/ 17 RPM lift motor, rain sensor, variable speed 13. Also, can this be replaced from inside unit? | The Replacement Fan Motor Assembly Kit # FVK8017-00 is the correct replacement fan motor for your...
How To Remove Motor on Kwikee 24/25 Series Electric Steps
I’m trying to replace the motor for my steps. I know it’s an easy process normally but my issue is I can’t remove the screws/bolts holding the motor to the gear plate. One bolt has a nut that I could reach and remove, so that one was not a problem....
Receiver Hitch for 2007 Newmar Class A Motorhome on Spartan Chassis
Hi, I have a 2007 Newmar ALlstar Class A motorhome on the spartan chassis. I am looking for a replacement class 4 or class 5 hitch for it. I have confirmed with the manufacturer that this is within the specifications of my RV. Hoping you have...
Bike Rack Compatibility with Motorhome While Flat Towing a 2015 Kia Soul
S44FR I would like to use this bike rack in a dual receiver hitch on my Newmar motor home, while flat towing a 2015 Kia Soul. I currently flat tow the Soul with a Roadmaster tow bar and a 2inch receiver. Will this bike rack contact the towed...
Why Do Some Kitcken Sinks Not Have Holes for the Faucet
25x17 off set white kitchen sink That is the correct size I need but my old sink has the holes for the faucet. Where are the holes for the faucet on the white sink | Some RV sinks include holes in them while others are designed for the faucet...
Replacement Fan Blade for 1979 Pontiac Trans Am For Clutch Application
Can this fan be used on a fan clutch in a 1979 Pontiac Trans Am olds 403 v-8? | The Derale fan part # D17418 that you referenced was not designed to attach to a fan clutch. For a similar size fan that is and the correct direction for your 1979...
Replacement Monitor For Voyager AOM-7694
Will this VOM719WP be a good replacement for my AOM-7694 which has died. | The Voyager Monitor # VOM719WP will replace your AOM-7694 monitor per Voyager, but you will have to splice the existing wires from your AOM-7694 to the new Voyager Monitor....
Replacement Lens for Petersen Clearance Side Marker Trailer Light With Reflex Dimensions
What are the masurments on this lense | I went out to our warehouse and measured the Replacement Lens for Petersen Clearance Side Marker Trailer Light with Reflex # PE95ZR, and measured 3-3/16" long, 1-5/8" wide, and 2-3/4" on center between...
Seat Cover For RV Captains Seats in a 2013 Newmar Canyon Star Motorhome
Please help me find a replacement drivers/passenger seat cover for 2013 Newmar Canyon Star. Any suggestions? | At this time the Classic Accessories RV Captain Seat Cover # CA80112 is the only seat cover we carry. This cover is designed to fit...
Recommended Suspension Upgrade for 2011 Newmar Canyon Star 3920
Any recommendations on an upgrade to suspension to help with sway on 2011 Newmar Canyon Star 3920? | I recommend adding front and rear SumoSprings to your RV. For the front kit you would need # SSF-173-40-2 and for the rear use # SSR-187-54-1....
Electric Fan Kit Recommendation for 1981 Pontiac Firebird
Hi. Is it possible to add clutch to fan without chlutch? My Firebird has crate engine and previous owner put fun running by belt. It gives a power to water pump also. Thanks | Most people when upgrading either type of belt driven fan end up...
Correct Snap Pads for Newmar Canyon Star Motorhome
Snap Pad. I have a 2016 Newmar Canyon Star with Equalizer leveling system. Which Snap Pad will fit my coach? | I recommend measuring the feet on your leveling system and noting the shape of the pad. That said, it should be 9" round pads and...
Converting Older Flat Bar Hitch to Traditional 2 Inch Receiver on 1996 Pontiac Firebird
NEED TO CONVERT FLAT BAR TYPE TO 2 SQUARE TYPE. 1996 FIREBIRD | There are no available adapters that would convert your flat bar receiver to a 2 inch receiver, nor is there a 2 inch receiver available for the 1996 Firebird. The Class I receiver...
Trailer Hitch Fit for 1998 Pontiac Trans Am
Says it fits 1998 firebird, how about trans am? | The Curt Class I Trailer Hitch Receiver # C11117 that you referenced is confirmed to fit both the 1998 Pontiac Firebird and Trans Am. I confirmed the fit of the hitch on a 1998 Trans Am with...
Will the Curt Trailer Hitch Part # C11117 fit a 1984 Pontiac Firebird with Dual Exhaust
My car has dual exhaust. Will this hitch fit? | I spoke to my contact at Curt Manufacturing and they stated that as long as the dual exhaust you have on your 1984 Pontiac Firebird was installed from the factory, then yes the Curt Trailer Hitch...
Replacement Headlight Housings and Bulbs for 1996 Pontiac Trans Am
Looking for a. Upgradedhousing for my 1996 pontiac transam 4645 sealed HEAD light I have a set of housing which are. No good There set up for h-4 bulbs. What options due you have | As long as your 1996 Pontiac Trans Am features 4 inch x 6...
Filter Your Search
Contact and Help