Search: trailer couplers   >   Accessories and Parts   >   !Tri-Ball  x   >   Blue Ox  x   >   Hopkins  x   >  

This is a fairly straightforward install. GM has already run some of the necessary wiring from the rear frame rail area to the engine compartment, so you will see a blue wire for the electric brake function, and an orange wire which provides 12 volt…

First, make sure that you have the correct size Bearing Buddy. It should be slightly larger than the hub bore though it is difficult to tell just by looking. If you can tell me the outer bearing number I can determine which is the correct model.…

Yes, your 2007 Honda Fit Sport with a manual transmission can be flat towed behind an RV. You'd need to start with a base plate kit like the part #521558-1 which is a confirmed fit. In addition to the base plates, you will also need a compatible…

There is certain equipment required by law to flat tow a vehicle. That equipment includes base plates, a tow bar, safety cables, lighting, and supplemental braking. If you just need to tow the 2000 Chevy S10 once or twice, the expense is likely not…

The 168255TC oil seal is designed for use on for oil bath hubs, but they can be used on grease hubs. They basically just provide a better seal to hold oil in; they will still work for grease. The springs on your oil seals are required to function…

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…

Yes the coupler part #DM13689-52 that you referenced is lockable. For a pin style lock the part #28012 would work well. Or for a lock that goes around the coupler opening the part #BLTL-20-40D would be a great option. I attached review videos for…

The HydraStar Electric Over Hydraulic Actuator for Disc Brakes - 1,600 psi #HBA16 you were looking at is the correct Electric Over Hydraulic actuator for the disc brakes on your tandem axle boat trailer. You can lock out your Titan Model 10 surge…

Dexter Trailer Springs Over-Under Conversion Kit, part #K71-384-00, is specified by Dexter for use only with double-eye springs. It is not suitable for use with slipper springs. It is considered by our technical friends at Dexter to be unsafe to use…

Since one end of a slipper spring is suspended instead of bolted to a hanger or shackle strap the Dexter Trailer Springs Over-Under Conversion Kit part #K71-385-00 and other likes them are considered unsafe for slipper springs. The only other option…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Given the information that you were able to provide, it sounds like you likely have the Extang Revolution Soft Tonneau Cover. I have included a video of this cover so that you can compare your cover to the Revolution. Unfortunately that cover is no…