Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
All of the electrical readings you are getting on your electric brakes sound normal and the lower amperage readings are likely due to additional resistance due to the longer wiring used on the rear axle. It sounds like there is either an issue with…
view full answer...Since your tandem axle trailer only has brakes on one of the axles, you will just need a single axle kit like the Kodiak Hydraulic Brake Line Kit #18SI-BLKIT you were looking at. This kit includes an 18 foot, 7 foot and 1-1/2 foot long flexible…
view full answer...The Class II hitch I recommend for your 2018 Subaru Outback Wagon is the Draw Tite hitch part #36493 if your plan is to carry a hitch accessory like a bike rack or cargo carrier as it does not require a stabilizer strap like the Curt does. If you…
view full answer...To wire in the reverse light wire on Curt 7-Way connector #C57102 for the back up alarm to work you will need to tap into a reverse light wire behind a reverse light on your 1999 Dodge Ram. If you do not wish to tap into the wire there then you can…
view full answer...Yes, I attached an install video that shows the Pollak part #PK12-707E (same as number you mentioned) installed in a newer GMC to this page.
view full answer...90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to…
view full answer...I wish we could help, but only option we can point you towards would be new axles as what you sent in a picture of is not compatible with anything we sell. You are going to need to measure your current axles in a few places to get the correct one…
view full answer...On your Barrett Gooseneck Trailer, if your brake magnet wires are not connected to the trailer brake wires, you will most likely be getting a current from the trailer breakaway battery on one of the two wires. You need to connect one of the wires…
view full answer...For your 2019 Jayco Jay Flight SLX Travel Trailer and with you wanting to go boondocking for multiple nights I recommend the Go Power Lithium RV Battery - Deep Cycle - LiFePO4 - Group 4D - 12V - 250 Amp Hour Item #34282740 For a solar set up I…
view full answer...The spindle that is on the Dexter Trailer Idler Axle w/ Idler Hubs #20440I-EZ-60 is a BTR spindle like part #TRU44FR. . The stub diameter (A) on the TruRyde spindle is 1-1/4 inches, The part where the grease seal rides (B) is 1.5 inches. It uses…
view full answer...To install the Redarc Tow-Pro Liberty Brake Controller item #RED24FR in your 2019 Toyota Tacoma all you will need is the Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR. I have attached a couple of pictures…
view full answer...Filter Your Search
Contact and Help