Toyota  x   >   Venza  x   >   2011  x   >  

Will this work on a Venza with glass top? | Per Yakima, the YakimaFullBack 3 Bike Rack, part # Y02633 is a confirmed fit for your 2011 Venza with the panoramic roof. I have attached a photo that shows the # Y02633 installed on the rear of a...

I have taken my hub off the axle and measured surfaces B, C and D and E and they correspond with part no. TRU47FR. This is the spindle for the T4843100 Brake kit. I need to know where the F measurement is taken. | The F measurement is the length...

Hi, I have a 2011 Toyota Venza with a sunroof and moon roof, but it does not have a roof rack installed. I would like to purchase the Thule Hullavator Pro Kayak Carrier and Lift Assist, so Im wondering if you can direct me to a after-market...

Im looking for a brake controller for my 2011 Toyota Venza and just want to confirm that the Tekonsha P2 90885 will do. I have a 4 pin plug in the back so would I also need your adaptor #37185 4 pole to 7 pole. Would I need anything else? Thanks...

What is the best 2 bike rack solution for a 2011 Toyota Venza? | In my opinion, the best trunk mount bike rack that is available for the 2011 Toyota Venza is the Thule Raceway 2, # TH9001. What makes this bike rack rise above the others is the...

Installed wiring kit C56079, couldnt be easier. Fuse is installed and still good Flat plug has power to all three pins using a test light grounded to the exhaust. Plug it in to my small trailer and get nothing. Plug the trailer into another...

Hi there, I have a 2009 Toyota Venza and am switching the hitch to my newer 2011 Toyota Venza. Can you please tell me what size of bolts are needed? I should purchase new ones rather than recycling the old. As well, will my older wiring kit...

Im pulling an RPod with a Toyota Venza. I would like to mount a camera on the back of the camper so I have a more complete view of what is going on behind the trailer while Im driving or parking. I like the idea of the unit sending a signal...

Can this harness be powered by taping into the auxiliary plug in the back of the vehicle. It is rated for up to 20 watts. | The power wire on the Tow Ready Trailer Wiring Harness, # 118482, for the 2011 Toyota Venza, has only been tested and...

I am a repeat customer and have recommended etrailer.com to all of my friends who are in the market for hitches and accessories. I purchased a hitch Hidden Hitch and wiring harness 118482 from etrailer.com a couple of years ago for my 2011...

I have a Thule aeroblade 53” roof rack, what size fairing would you recommend? Thanks | When looking at fairings you always want to choose one that spans the space between the legs of your roof rack. For your application the 44" long AirScreen...

my bike rack carries 4 and the size is 2x2 . will it fit in the curt trailer hitch? | The CURT Trailer Hitch, # 13356, is a Class III trailer hitch with a 2 inch receiver. It can handle a 4 bike trailer hitch mount bike rack and accepts racks...

Please confirm if this is the correct roof rack for a 2011 Toyota Venza with a panoramic sunroof. Thank you | Yes! The Yakima Roof Rack system for Naked Roofs is confirmed to fit your panoramic roof on your 2011 Toyota Venza. This is a perfect...

Can this be use with kids bikes and women bikes | Yes, you can load women's and children's bikes on the Yakiam FullBack # Y02634. But any bikes that do not have a top frame bar that goes straight across (like a typical men's bike would) then...

Im installing a hitch on my Venza AWD, can I remove the 4 sway bar bolts while the car is sitting on jack stands? The video shows the vehicle is propped up on ramps. | Yes, the sway bar hardware can be removed on your 2011 Toyota Venza with...

What size and kind ofroller do this bracket take? | For a roller bunk bracket designed for roller bunks you would want a Boat Trailer Roller Bunk Bracket # DL21742. If you wanted a set of roller bunks for this bracket I would recommend the Boat...

I want to order the CURT 12341 hitch for my 2011 Toyota Venza. I have a Yakima 2 bike hold up bike rack. It doesnt have a vertical center post to attach a sway strap to. The bikes rest on their wheels and a rod moves up to attach to the front...

I just installed a hitch trailer with the opening 2. Then it doesnt fit to my bike rack 1 1/4. My question: 1. is this the right choice? 2. is the lenghts right too? | You have a couple options, you could use the Hitch Adapter 2" to 1-1/4" #...

I want to buy a hitch and a Thule 2T bro bike rack to carry 2 hybrid bikes. I also own an A2B e-bike, weighing 73 lbs. It would nice if I could use the rack to transport that without any other bikes when I need to transport it for servicing. Im...

Hi, on your video of the installation of the above named product you mentioned using a spacer block to reattach the sway bar bracket. Is that supposed to come with the hitch? Thanks, | Yes, the spacer blocks are included in the hardware that...

Just wanted to know why it says you cannot install the Thule aeroblade traverse on a Toyota Venza with a sunroof. Will it distort the shape of the sunroof? | Yakima has a roof rack that fits the 2011 Toyota Venza with a naked roof and a sunroof,...

Have a 2011 Toyota Venza with factory towing package, factory trailer wiring harness and Reese hitch. Want to add a P3 controller but the vehicle specific controller listing on your site has a yellow highlighted note that says without factory...

What chains do you recommend for Toyota Venza 2011, tire size 245/55R19. Do you have any THULE brand that will fit that have the self adjusting feature. I prefer the diamond if possible. | We do offer several tire chains and cables that...

Hi, I am interested in this particular roof rack - Rhino-Rack RS 2500 Roof Rack for Naked Roofs - Vortex Aero Crossbars - Aluminum - Black part number: RR37YR My concern is: I have a 2011 Toyota Venza with a glass roof and a sunroof. Im looking...