Can Sway Bar Hardware be Removed From 2011 Toyota Venza While on Jack Stands
Published 08/10/2017
Question:
Im installing a hitch on my Venza AWD, can I remove the 4 sway bar bolts while the car is sitting on jack stands? The video shows the vehicle is propped up on ramps.
asked by: Mark
1
Helpful Expert Reply:
Yes, the sway bar hardware can be removed on your 2011 Toyota Venza with it jacked up in the air. There does not need to be a load on the suspension. With suspension hardware your best bet is to torque it all down with a load on the suspension as that will prevent any weird creaks or groans.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement for a Sharp Carousel Microwave R-820BK-F
- Q&A: Recommended Replacement Water Heater for Old Busted GH6-7E
- Q&A: Curt or Draw-Tite Class III Hitch for 2015 Toyota Venza
- Q&A: Can Trailer Hitch be Installed on 2015 Toyota Venza With AWD All-Wheel Drive
- Q&A: What is the Difference Between the etrailer and Curt Hitches for a 2023 Subaru Forester?
- Article: Holiday 2025 | Best Gifts for Towers
- Q&A: How To Measure For Hitch Receiver Lock Pin Span
- Q&A: Trailer Hitch and Bike Rack Recommendations for a 2013 Toyota Venza
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Hitch Installation Tips
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop