Result:

Articles

Why Choose a Powered Taillight Converter Over a Non-Powered Model

What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...

Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter

Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...

Finding Installer for Curt Hitch on 2009 Kia Rondo

A Curt Trailer Hitch Receiver for a Kia rondo 2009 what car brands aré compatible to install the tráiler Hitch | Hey Adrian, I attached a link to an installer locater that you can use to find someone to install the Curt hitch part # C11031 on...

Troubleshooting Hitch Bolts Not Fitting Weld Nuts on 2006 Pontiac Torrent

2006 Pontiac Torrent. The four bolts that go on outside dont fit into the hole. I sprayed it and cleaned it the best I could and cant get the bolts to thread. The two on the bottom middle fit with some resistance. Do you have any suggestions...

Parts Needed to Add Brakes to 1992 Coleman Arcadia Pop-Up Camper

I want to add brakes to my 92 Coleman Arcadia pop-up. I am looking for the correct hub/drum and electric brake assemblies. The wheel bolts are 5 on 4 1/2 and the tires are Carlisle USA Trail 20.5x8-10. The current axle includes a square flange...

Bolt Size for Trailer Hitch Installed on 2006 Pontiac Torrent

Hi I was just wondering what size bolt I need for installation of a hitch on my 2006 Pontiac Torrent | For the hitches we offer that fit your 2006 Pontiac Torrent like the etrailer part # e98865 the size hardware that comes with it is M12-1.75...

Items Needed to Tow a Trailer with a 2011 Lexus RX350 Without Tow Package

I bought a 2011 RX350 Canadian version that was not ordered with the tow package. What do I need to install to properly tow our 2500 lb boat? | To tow your boat trailer with your 2011 Lexus RX350, you will need a trailer hitch, wiring harness,...

Two Front M12 Bolts Will Not Tighten with etrailer Hitch e98865 On a 2007 Pontiac Torrent

I had two problems with this install. The two weld nuts under the license plate never torqued down. They were the only ones that I could tighten easily, but they never tightened up to the proper torque level. Second problem, the rear bolts...

Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross

I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |

Replacement 1200 Pound Dutton Lainson Brake Winch

I have a Shorestation Jetski lift that Im told uses a 1200 brake winch. The current one has the DL logo on it. Would this unit be the correct replacement? Picture attached. | It isn't exactly the same, the housing design has changed, but...

Trailer Hitch Recommendation for a 2007 Kia Rondo

I am looking for a trailer hitch for a Kia Rondo that was manufactured in Dec, 2006. I dont see one in your listing earlier than 2007. Thank You | That is because you most likely have a model year 2007 Kia Rondo that happened to be built in...

Recommended Trailer Hitch Receiver for 2011 Kia Rondo

I am looking for a trailer hitch for my KIA Rondo 2011. Do you guys have anything for this models Thanks | For a trailer hitch that fits your 2011 Kia Rondo we have the Draw-Tite Trailer Hitch Receiver # 36525. This is a custom fit Class I...

Which Brake Switch Wire on 2008 Pontiac Torrent to Connect to Tekonsha Voyager Brake Controller

I purchased this controller from you for my 2008 Pontiac Torrent. I am having a problem with finding the wire on the brake switch that goes hot when the brake is applied. The break pedal wire did not light up my 6 to 12 volts tester. I assume...

Reese Brakeman 83501 Only Sends Power to Trailer Brakes When Using Manual Over Ride

I have installed this unit on a 2007 Pontiac Torrent. The instructions say to attach the red wire to the cold side of the brake pedal switch. On this vehicle the brake pedal switch has 3 wires. The grey wire is always hot 12v. The blue wire...

Wiring Harness With Easy Install For 2009 Kia Rondo

I am interested in the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector for a 2009 Kia Rondo. One of the issues I see in the reviews is that the green wire from the drivers side to the passenger side can be too short....

Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails

Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...

Troubleshooting Wiring Harness # C55560 When Installing on a 2006 Pontiac Torrent

installed in my 2006 torrent power getting to the end of wire but nothing to trailer .trailer lights working fine how do I get them to work ? | The first place I recommend checking is making sure the ground connection is good on the wiring harness,...