Pilot  x   >   !Tow Ready  x   >   Safari  x   >   No Boundaries TT Toy Hauler  x   >   Deka  x   >  

I got the hitch for my 2016 Honda Pilot. The bolts do not fit in my pre made holes. They are M 14. I went and got M 12 they are to small. Any suggestions? The videos on here show how easy it was to installed. | The M14-1.5 x 40 bolts are the...

can this unit 41125 be used on a gmc safari | To install a 4-pole trailer connector on your 2000 GMC Safari, you'd use part # C55411. Installation would be pretty simple, as there is a wiring harness that ends in bare wires located in the jack...

How can i install rest of 3 wires for my Honda Pilot 2016. I have already connect 4 way plug to my current 4 way Plug C56291 and i have ground wire connected to car metal plate. Now i have question regarding below 3 wires.. Yellow wire is...

Looking for a trailer brake. I have located the controler on your site but need the brakes. I have a Dexter 3500# torsion stub axles. The four hole plate is there but not being used. There is a 5 hole for a 15 rim, 30 Firestone destination...

So I have noticed that if the tail gate is open for long periods of time, even if the interior lights are turned off, the Pilot goes into standby and kills the battery. How do you use the Pilot tent attachment with the tail gate, presumable...

All the video I can find assumes a tow package. I dont have one. How do I connect trailer wiring without a package? Especially, is there a power supply wire available in the rear to power the converter and possibly a 7 pin plug, or do I have...

Hi, I have a 2000 Coleman Taos and it does not have electric brakes. It does not appear to have an axle capable of accepting electric brakes. Im prepared to replace the axle in order to add brakes. In this case I feel its better to replace the...

Im researching a contingency for upgrading the 2010-2016 Ford F-250 through -550 specific example: 2016 F-250 from the stock 7+4-pin Pollak dual socket, 6-blade+1-pin utility paralleled by 4-pin flat to a 9-pin set-up backwards-compatible with...

My trailer has 6 poles connector. I got this #118336 from etrailer. Connect to 4 to 6 pin adapter to trailer 1 If I already have electric break, what more do I need? Controller? 2 If I dont have breaks, what more do I need? | Since your trailer...

I want to use Tekonsha Prodigy P2 Trailer Brake Controller 90885 for 2015 MB Sprinter 2500 with MB factory trailer hitch and 7 pin plug. Which Plug the brake control end of wiring harness into back of brake control and vehicle end into vehicles...

Hi There! I’m doing some pretty basic troubleshooting with my Honda Pilot 2015 I’ve had the 7 pin tekonsha t-one wiring installed since I’ve owned the vehicle, it’s worked great on many a camping trip towing a few different campers, until 2018 Fast...

2009 Honda Pilot LX 2WD with standard factory hitch, but the 7-way was installed by a local shop, not factory. Worked fine with my no-brake PUP, but now I have a newer camper with brakes which came with a Primus IQ 90160. I bought a 3070-P,...

Good Morning, I looking to add electric brakes to my 1997 Coleman by Fleetwood Destiny Series Santa Fe pop-up camper. I have went through everything and just want to make sure that I have ed all compatible parts that I will need for my installation. The...

2014 Honda Pilot AWD EX, not that it directly matters to the question. As seen in the product image, and real life, this Tekonsha 3070-S brake controller wiring adaptor kit is supplied with 2 Blue 16-14 Ga and two Yellow 12-10 Ga barrel crimps....

I need to wire my 2005 honda pilot for towing with my motor home I have a 7 flat pin male socket on the rv I have the roadmaster air brake accuator .I need a wiring kit to cover lights and stop cancelling turn signals when braking .if...

I am seriously looking at the Redarc Trailer Brake Controller - RED24FR. Is there an installation video? If difficult I would pay a shop to install. I will be pulling a one-axle A-Liner and do not expect to be off-road much of the time. Also...

Wired heater with switch pk34360 and wires melted. I wired the heating pad and switch as shown in your diagrams and picture of switch pk34360 when I turned on the switch the wires melted both red and white. Wires on the pad side do not appear...

What are the inner dimensions of the Vented Battery Box, so I can make sure my battery will fit in the box? | I went out to the warehouse and pulled the Vented Battery Box, # DW03188, and produced a short video showing the dimensions of the...

Hi! Ive been looking over your web site and here is the route Im thinking: 1. Tekonsha P3 Brake Controller with Honda adapter: CEQ90195- 3070T 2. 7-way vehicle adapter with test lights, C57674 My unresolved questions all deal with the lack...

I recently purchased the Tekonsha 7 way harness Code: 118286 and installed it on my 2016 Pilot EX 2wd. My understanding is that with this wiring harness, when i apply my brakes on the pilot, my electric brakes on my camper will be engaged....

I recently installed the T-One vehicle wiring harness 7 pin on my 2016 Honda Pilot. My trailer is a 4 pole flat connector. Will this be able to charge my trailer battery? If not, what do you recommend? | A 4-way trailer wiring harness would...

Hi I have the trailer package on my 08 Honda Pilot w/flat four connector. I need a flat 5 for my boat trailer surge brakes. Where do I find that fifth wire? I know it atttaches to the backup light power but am looking for an easy way to connect...