!Designer Camper  x   >   Boone Outdoor  x   >   Project Pro  x   >  

I go hunting a lot with my enclosed trailer and I was wondering how can I install a led light bar on the trailer but I want to switch it on and off in my truck | You can definitely install a light bar on your trailer and control it with a switch...

We have the Hollywood Racks Sport Rider HR1400 and wondering if this storage rack would work to store the two main sections of the bike rack separately. i.e. the main 2-bike attachment with 2 bikes on top or bottom and the add-on 2-bike attachment...

Hi, I have a Curt C11330 trailer hitch installed on a 2008 Scion tC. I need to install a 1-1/4inch to 2inch hitch adapter and was deciding between the Brophy HTAD and HT5R. My preference is the HTAD because I dont need any additional rise,...

looking for a 5 wire harness for a headache rack on a 2020 ram 3500 8 bed. | I have an option for you, but there is not a 5-way connector that is custom fit for your 2020 Ram 3500 and will allow to also hook up a trailer. I recommend using...

Is the angle of the docking station fixed, or variable? How far away from the wall must the foot be mounted? | Boone states that as long as the bottom plate of the Boone Docking Station Bike Rack Storage # BH92422 touches the ground it can...

our flagpole is 1.25 in diameter do you have a base that would fit so the wind wont knock it around | The GameDay Tailgating Drive-Up Flag Pole Base # 79553 would work well for you as it can fit flag poles that are up to 1.875 inches in diameter....

Greetings, i recently purchased Camco Hitch Mount Flagpole Holder — 2 in. Receiver Mount, Model# 51611 The mount accepts a flagpole up to 2inch inches wide at the base. Im considering using this flagpole with it. How wide is the flagpole...

Hi, i am looking for an anti wobbling device for Yakima BigHorn 4-Bike Hitch Mount Rack. used with 1.25inch hitch. What can you recommend Thanks, | To reduce the movement in the trailer hitch with your Yakima BigHorn 4-Bike Hitch Mount Rack,...

It says you can fly two individual flags on two sets of clips, but it doesnt say what size flags? Also, how long is the flat, drive on section of the base? Is the base and flag pole gauranteed? | The snaps will slide on the pole some so the...

I just received Part #D-55007. It is very loose and rattles a lot. Will this wedge work with a vertical ball mount? Thx | As long as the Vertical Drawbar part # D-55007 is being used in the correct Curt Hitch part # C11748 you can use the...

How does each section of the pole lock in place as you raise it to its full height? | I went out to the warehouse and pulled Sports Fan Telescoping, Fiberglass, Multiple Flag Pole # 94999. When you extend the pole it locks into place with friction....

Someone cut the cable to my winegard voyager WiSight backup camera. Can you tell me how to splice it back together? Thank you | Thanks for the picture! Based on the picture you sent in you may have enough room to use heat shrink butt connectors...

My dog recently chewed through the wires on my Lippert PSX2 Stabilizer motor on my 21 Rockwood 2608bs. I see a couple of phillips head screws on the outside. Can I remove this and attach a new wire? Is there any kind of replacement boot that...

Hello, do you sell a 14 5 wire flat connection that has a protective coating on it? | I may have an option for you but we do not sell a 14' 5-way flat connector harness that has a protective coating on it other than the wiring insulation. I...

How much does the whole thing weigh and what are the dimensions? | The Boone Outdoor Hardware Tailgate Table # BH70114 referenced in your question weighs only about 22 pounds. The table top itself measures 20 inches wide and 48 inches long....

Does Boone Outdoor Tailgate Table work with 2 inch trailer hitch? If not will an adaptor cause it be wobbly? other thoughts? Will it work for the car above re: using the trunk as our seats? | You can indeed use a hitch adapter to pair a 1-1/4"...

Will a Curt 18153 60 in. x 24 in. Steel Basket Style Hitch Cargo Carrier for 2 in. Receiver fit on the bottom dock between the dock and the wall backward facing storage similar to that pictured in the two videos if the cargo carrier is in the...

The 2inch model includes a cover does the 1-1/4inch also it is not clear? I just ordered the 1-1/4 model today but I only want it if it includes the cover. | Yes, the Boone Outdoor Hardware Tailgate Table # BH70114 that you referenced does come...