22" x 1". Low-profile LED utility light provides bright light to an interior space. Durable polycarbonate housing and lens. Surface mount - hardware not included. 2-Wire design. 27 Diodes.
I wasn't able to find any model information on your Sunlink RSBF3NN-008 and we don't carry that particular brand, but we do have a number of recessed puck lights available that may work for you. You may be able to use the Gustafson RV Puck…
I have a solution for you, but the main issue with puck style lights that mount to the surface of your RV ceiling or under cabinets, is that there aren't replacement bulbs available and they aren't really designed to have the bulbs replaced.…
No, you don't want to put Kilz down. The adhesive for the LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane item #344270KIT35 won't stick to the primer. It needs the bare wood. The item #344270KIT35 install kit comes with everything…
Hey Mike! The Gustafson 12V RV Vanity Light #277-000322 can use LED light bulbs. The 912 and 921 bulbs are interchangeable since they have the same T-5 wedge base. The 921 draws more power and will burn brighter than the 912 so that is the…
I recommend replacing your lights with the LED RV Dome Light w/ Switch #RVILL50. These LED lights will outlast and use less power than the florescent tube lights in the Liteco 179 that you currently have. These lights are 15-3/4" long x…
Hey Doug, I don't have a way to look up the axle info on your camper. If you can't find tag on the axle you might check up on the VIN plate of the camper to see if you can at least get the axle capacity or GVWR from there and we can go from…
The Opti-Brite LED Interior Light part #ILL08COB and part #ILL10CCB are idenical lights for the exception of the number of diodes they contain. The light ending in "COB" contains 8 diodes whereas the light ending in "CCB" has 10…
The bulb for the Gustafson 12V RV LED Pendant Light w/ Light Shade #GUS62VR is just below the stem so you would have to completely disassemble the light in order to replace the bulb. The portion inside of the shade that short of looks like the bulb…
Hey Doug, According to my research you're going to need the Replacement Kwikee Electric Motor Assembly with 14NM IMGL RV Steps #LC75JX. This doesn't come with any cables/sensors, but if you let me know what you're needing, I'd be more…
We have a Lippert Components replacement slide motor that will work with the Schwintek system. It is the Lippert In-Wall RV Slide-Out Motor #LC236575. It is a gear ratio of 300:1.
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
Filters
