LED Strip Lights Specs:
Features:
9" Long x 1" wide x 5/8" thick. Low-profile LED light strip illuminates an interior area. Built-in switch controls on/off function. Surface mount - hardware not included. 2-Wire design. 9 LEDs.
More Information >Videos
for RV Interior Lights
Help Articles
for RV Interior Lights
Expert Answers
for RV Interior Lights
As you have a Coleman Mach system currently you can use the Furrion Chill AC units from the list below. These will simply replace only the rooftop units and the controls and thermostats you currently have in place with control the new…
view full answer...Yes, you will be able to use the Furrion Chill HE RV Air Conditioner System #FR87FJ to replace all your Coleman MACH components. The thermostat will be able to control your furnace and run off the thermostat wiring your Coleman AC uses.
view full answer...I have a solution for you, but the main issue with puck style lights that mount to the surface of your RV ceiling or under cabinets, is that there…
view full answer...The 12v accessory pin from the 7-way would need to be connected to the battery in order to charge it so…
view full answer...Welcome back! We do not sell the breakers…
view full answer...The 125255UC seal has a…
view full answer...The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer…
view full answer...The pre-wiring of Furrion pre-wired RVs is basically just two wires as well as the Voyager harness like part #PSVCWVCMS130AP. One wire is the power wire which is the running light circuit and then the other is the ground so it really would just be…
view full answer...Since we are not 100% sure of the serial number on your 2015 Keystone Cougar 279RKSWE I recommend verifying the bolt measurements on the pin box. A 1621 pin box is going to have the…
view full answer...You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.
view full answer...I reached out to Lippert who informed me your Power Gear controller 140-1224 Rev 0G is obsolete. It was replaced with the Lippert part number 372854 but that part is also now obsolete. At this point your options are to try and have your controller…
view full answer...