Edge EZ Programmer For 2000 Dodge Ram With 5.9L Cummins Diesel Engine
Published 11/12/2014
Products Featured in This Question
Question:
How do i change my settings on my Edge EZ for my 2000 Cummins
asked by: Roy C
Expert Reply:
I spoke with my contact at Edge about your Edge EZ. You noted part # EP30204 and that you have a 2000 Cummins.
The # EP30204 is designed to work with 2004 through 2007 Dodge Ram pickups with a 5.9L Cummins Diesel Engine only.
If you have a 2000 Dodge Ram with a 5.9L diesel, the Edge Performance Chip that is designed to work with your truck is part # EP30200.
Either one of these units comes with a toggle switch that allows you to adjust the settings. I have attached a photo of the toggle switch and the 3 positions are noted. The position closest to that tab is level three. Forward one setting is level two. And all the way to the opposite end of the tab is level one.
Product Page this Question was Asked From
Edge EZ for Dodge Cummins 5.9L, 24V, Common Rail
- Performance Chip
- Performance Tuners
- Tuner Only
- No Display Screen
- Yes - California Approved
- EZ
- Edge
more information >
Continue Researching
- Q&A: Can I Use Hubs with 3500-lb Capacity on Axle with 1750-lb Capacity If The Bearings Match Up?
- Q&A: Replacement Hub for Older Dexter 8-245
- Q&A: Replacement Switch and Cable Recommendation for Edge EZ Programmer # EP30204
- Q&A: Bearing Kit Recommendation for Dexter 8-248 Hub
- Q&A: Toggle Switch Positions on the Edge EZ Programmer 30204