What are the Dimensions of the Mounting Plate for Fulton Trailer Jack FHD2500
Published 10/16/2014
Question:
I got most of what I needed from the video except the overall dimensions of the mounting plate including the offset of the tube from the mounting plate face part with holes. Also, what is the outside dimension of the square outer tube and square inner tube?
asked by: Bruce S
Expert Reply:
I went out to the warehouse and pulled Fulton trailer jack # FHD2500 to take the measurements you need. The mounting plate attached to the jack measures 6-1/2 inches tall and 6-1/2 inches wide overall.
From the trailer frame to the outer tube of the jack measures 1 inch.
The outer tube is 2-1/4 inches. The inner tube is 1-15/16 inches.
Product Page this Question was Asked From
Fulton Square, Fixed-Mount Marine Jack - Drop Leg - Sidewind - 30" Lift - 2,500 lbs
- Trailer Jack
- Boat Trailer
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Marine Grade
- 2001 - 3000 lbs
- Manual Jack
- 30 Inch Lift
- Bolt-On
- With Rectangle Foot
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: Will a Taller Drop Leg Fit Fulton 2.5K Square Fixed-Mount Marine Jack FHD2500
- Q&A: Does Grease Seal # 34823 Feature a Garter Spring
- Q&A: 12 Volt Accessory Circuit Relay Location in 2019 Ford F-250
- Q&A: Troubleshooting Weak Trailer Brakes That Won't Lock Up with Override Lever of Controller Slid
- Q&A: How Can I Replace Lippert Unity X1 Control Board Part 801171
- Q&A: Solution for Brake Actuator on 3-1/2" Trailer Tongue
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle