Dimensions of the Mounting Pipes on the Bulldog Jack part # BD190758
Updated 09/29/2014 | Published 09/28/2014
Question:
What is the o.d of the male pipe coupler and the i.d. of the female coupler? The female end gets welded in place correct?
asked by: Sam
Expert Reply:
I went out into our warehouse and to measure one of the Bulldog Square Swivel Jacks # BD190758 we had in stock and found that the inner diameter of the female mount is 2-17/32 inches and the outer diameter of the male pipe mount on the body of the jack is 2-15/32 inches.
Yes, the female end does get welded in place on your trailer frame.
I attached a review video for you to check out as well.
Product Page this Question was Asked From
Bulldog Square Swivel Jack w/ Round Pipe Mount - Drop Leg - Sidewind - 28-1/2" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 4001 - 5000 lbs
- Manual Jack
- 15 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Surge Coupler is on Military M1102 MCC Trailer
- Q&A: Can Replacement Left/Curb Side Leg e63VV Be Used As A Standalone Jack
- Q&A: Replacement Hub/Rotor for UFP 41030
- Article: Electric Jacks vs. Manual Jacks
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Q&A: Replacement Disc Brake Rotor for Dexter 10K/12K Axle
- Q&A: Dimensions of the Pro Series Round Pipe Mount Swivel Jack with Footplate
- Q&A: Retracted Height Dimension of the Bulldog Jack part # BD190708
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review