Parts Needed to Install a 7-way on a 2008 Chevy Equinox with 4-Way
Published 09/26/2014
Products Featured in This Question
Question:
is there a all in one harness for all this. vehicle currently has a 4 pin connector at hitch. trailer is a 05 Viking with inverter and 7 pin connector.
asked by: Rich
Expert Reply:
What you will want to install on your 2008 Chevy Equinox is the part # ETBC7. This comes with everything needed to install a fully functional 7-way on your vehicle. Since your trailer has an inverter you will at least need a 12 volt accessory circuit on the 7-way.
Most likely your trailer has brakes and you will need a brake controller. For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.
The # ETBC7 comes with everything needed to complete the 12 volt power circuit needed for the inverter and the brake controller I recommended. I attached an install video plus installation instructions for you to check out as well.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Trailer Hitch and Wiring for 2025 Hyundai Santa Cruz
- Article: Best Bike Racks for Electric Bikes
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Troubleshooting Trailer Wiring on a 2005 Chevy Equinox that Doesn't work With Trailer but Has Power
- Q&A: How is the 4-Way Accessed of Curt Trailer Wiring When Installed on a 2005 Chevy Equinox
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)