What Secures the Yates Keel Roller part # YR800Y to the Roller and Bracket

Published 09/16/2014

Products Featured in This Question

Yates Keel Roller for Boat Trailers - TPR - 8" Long - 5/8" Shaft

(297)

$26.31

Replacement Cap Nut - Zinc - 5/8" - Qty. 1

(202)

$3.11

Question:

I have just purchased a complete set of replacement rollers and shafts. I can not find any online references to how to secure the end caps which come with the shafts. What is the proceedure to secure these caps, once the shaft is installed with the brackets and new rollers? Is a tool required to secure the end caps? Thanks in advance,

asked by: Chris K

Expert Reply:

If you have a Yates Keel Roller part # YR800Y, the bracket it installs onto, and a roller but no way to secure it all together you are only missing pal nuts. For that you would want the part # 408600.

To attach a pal nut (part # CE10801) to the end of a roller shaft, you would simply tap it into place with a hammer or mallet.

The easiest way to do this is fully assemble the roller, shaft and bracket before installing it on the trailer.

Place the pal nut on the floor, open end up. Place the shaft through the roller and place roller and shaft in the bracket.

Then, turn the assembly on its side with the shaft inserted into the pal nut on the floor. Place the other pal nut on the other end of the shaft, and use a hammer to seat the top nut, which should also seat the roller shaft into the bottom pal nut at the same time. Once the nuts are seated, you can attach the roller assembly to your trailer.

expert reply by: Jameson C