How Many Andersen Camper Levelers Per Axle Are Required For a Camper
Updated 09/05/2014 | Published 09/02/2014
Question:
3604leveler do i need onefor each axle on each side?
asked by: Wade
0
Expert Reply:
To use the Andersen Camper Leveler, part # AM3604, you would either pull forward or back on the leveler and then place the wheel chock under the edge of the leveler to make sure it does not shift.
The contacts at Andersen have confirmed that only one leveler is needed per axle. I have attached a product review video for the leveler you can check out.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Andersen Camper Wheel Chock and Leveler
- Wheel Chocks
- Wheel Chock
- RV
- Trailer
- Plastic
- Smooth Surface
- 1 Chock
- Red
- Andersen
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does Brandmotion FullVUE Digital Rear View Mirror with HD Backup Camera Come with CHMSL Camera
- Q&A: Which Replacement Anti-Rattle Hitch Pin bolt Fits Yakima Long Haul Bike Rack
- Q&A: Is Fascia Trimming on 2026 Honda Passport for Curt Hitch Installation Difficult
- Q&A: Will a Grille Guard For 2025 Toyota Tacoma Interfere With Sensors
- Q&A: Recommended 90° Sewer Adapter for a Dump Station
- Q&A: What is the Difference in the Gen-Y Nomad and the Gen-Y Executive for Rhino Pin Boxes?
- Q&A: Trailer Hitch for 2026 Honda Passport RTL
- Article: How to Measure for Trailer Hitch Drop
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What Do I Need To Tow A Trailer?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Converting Your RV Water Heater to Tankless
- Article: How Much Solar Power Do I Need For My RV?
- Article: Is It Illegal to Leave My Hitch on My Truck?