Does Skid Shield have to be Removed to Install Curt Front Mount Trailer Hitch on 2011 Toyota Tacoma
Updated 08/26/2014 | Published 08/25/2014
Question:
i understand that \you remove the skid plate and that will not be reinstalled when installing 31313 - correct? - Can you install driving lamps on the 31313 - is there enough room projecting from the front once installed to accommodate 2- 6inch lamps? thanks
asked by: Keith H
Expert Reply:
The skid shield may need to be removed to install Curt front mount trailer hitch # 31313. It might also be possible to trim it. The instructions do not mention the skid plate at all, see link to the right.
You should not drill into or weld to the hitch so if the lights can attach another way then it is possible to secure them to the hitch. Take a look at the picture of the hitch installed that I have included to get an idea of how much space there is after installation.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 350 lbs Vert Load
- 3500 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will The Curt Front Hitch 31313 Fit A 2007 Toyota Tacoma 4 Wheel Drive?
- Q&A: Removing Skid Shield to Install Front Mounted Receiver on 2014 Toyota Tacoma
- Q&A: Is Drilling Required for the Roadmaster MX Base Plate Kit on a 2007 Toyota Tacoma
- Q&A: Front Trailer Hitch Receiver That Will Allow For the Skid Plate To Mount On a 2008 Toyota Tacoma
- Q&A: Can a Front Mount Trailer Hitch be Used to Flat Tow a 1991 Jeep Cherokee
- Q&A: Will Gen-Y 5th Pin Boxes Void The Lippert Frame Warranty
- Article: Trailer Wiring Diagrams
- Q&A: Draw-Tite Front Mount Hitch on 2014 Toyota Tacoma
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations