Why Are My Mopeka M1001 Propane Tank Sensors Not Transmitting?
Updated 11/02/2026 | Published 11/01/2026 >
Question:
I have 2 M1001 Sensors that worked great, but they no longer transmit. Any suggestions?
asked by: Harold B
Expert Reply:
Hey Harold, thanks for reaching out. Since both of your Mopeka sensors were working fine and have stopped transmitting, the first thing I'd recommend is replacing the batteries. Each sensor uses a CR2032 coin cell battery, and a weak or dead battery is one of the most common reasons they'll stop communicating. Be sure to change the batteries away from any propane gas.
After replacing the batteries, make sure Bluetooth is enabled on your phone, open the Mopeka app, and press the sync button on each sensor to reconnect them. If they're still not showing up, try restarting the app and checking the connections again.
Have you already tried replacing the batteries, and did both sensors stop transmitting at the same time?
Product Page this Question was Asked From
Mopeka Propane Tank Check Sensors - Bluetooth - Qty 2
- Accessories and Parts
- Propane Accessories
- Smart RV
- Sensors
- Mopeka
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can Bulldog Winch RV Waterline Winterization Kit be Used with Short Neck
- Q&A: Recommended 3/8" Male Flare Propane Bulkhead Fitting
- Q&A: Recommended Air Safe Shock Absorbing Ball Mounts
- Q&A: Does Removing OEM Gooseneck Hitch Require Removing My Truck Bed?
- Q&A: Is the Mopeka Pro Check Propane Tank Sensor # MP67FR Sold Individually
- Q&A: Can I Use a 6-Ton Jack to Change the Tire on a 16,000 lbs Motorhome?
- Q&A: Towing Mirrors for 2004 Dodge Durango
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)


