Troubleshooting Door Switch of Aries ActionTrac Running Boards Not Working
Updated 10/26/2026 | Published 10/21/2026 >
Question:
the driver side door doesnt work, If I have the switch plugged in the back door wont work either. So right now i have the driver door unplugged so that the back door will work. AA3047902
asked by: David
Expert Reply:
Hey David, For your Aries ActionTrac Motorized Running Boards # AA3047902 the symptoms you're describing strongly suggest a problem with the driver-side front door sensor, its magnet alignment, or its wiring.
The reason I say that is that unplugging the driver's door sensor allows the rear door sensor to work again. That suggests the two sensors are interacting through the control circuit.
Here's how I would troubleshoot it:
1. Check the driver's door magnet alignment. Make sure the magnet lines up with the sensor when the door is closed. Also inspect the sensor for damage.
2. Inspect the wiring and connector. Look for pinched wires, corrosion, loose terminals, or damaged insulation near the driver's door.
3. Test the sensor with a multimeter. Aries uses normally closed door sensors. According to etrailer's troubleshooting information, the sensor should have continuity when the magnet is away and no continuity when the magnet is next to it.
4. Swap the front and rear sensors for testing, if they're identical and the wiring allows it. If the problem follows the sensor, you've likely identified a faulty switch. If it remains at the driver's front door, the wiring or magnet positioning is more suspect.

David
10/26/2026
Thanks for the info, it turned out that the front door switch as a little finicky about the magnet placement.

Product Page this Question was Asked From
Aries ActionTrac Motorized Running Boards with Custom Installation Kit - LED Lights
- Nerf Bars - Running Boards
- Running Boards
- 4-1/2 Inch Wide
- Cab Length
- Matte Finish
- Powered Retractable Step
- Aluminum
- Black
- Aries Automotive
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Motorized Running Boards for a 2019 Chevrolet Silverado 2500HD CrewCab Diesel
- Q&A: Aries ActionTrac Motorized Running Boards for 2019 Chevy Silverado 2500 Crew Cab
- Q&A: Do I Need One 12V PWM Filter VGR64VR For Furrion Camera System? Or Is It One Per Camera?
- Q&A: How to Program the Replacement Remote for Pace Edwards Bedlocker Retractable Hard Tonneau Cover
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: How to Determine if DeeZee Truck Bed Auxiliary Tank # DZ91752X Will Fit Under Tonneau Cover
- Q&A: Are Safety Chains Required When Using the Curt CrossWing?


David
10/22/2026
after messing around with it as you suggested it did start to work, The manet had to be at the extreme end of the switch to activate it. Thanks.