How to Remove the Mounting Plate From Optronics LED Awning Light
Updated 10/20/2026 | Published 10/17/2026 >
Question:
How do you separate the flush mounting plate, with attached rubber gasket, from the rounded light strip without breaking the plastic? Theres no room for a small screwdriver blade in the 2 small cutouts on the underside of the unit ILL70CBAWNFS.
asked by: John C
Expert Reply:
Hi John; based on your pictures, I would try using a thin plastic trim tool at the small cutouts to gently release the retaining tabs while pulling the chrome housing away from the mounting plate. You may need to work back and forth between the two cutouts to get it loose.
I would avoid forcing a screwdriver into the openings since you could damage the plastic tabs.
Product Page this Question was Asked From
Opti-Brite LED Strip Light for RV Awnings - Weatherproof - Chrome Housing - 18" Long
- LED Strip Lights
- Flexible Light
- Exterior Light
- Interior Light
- Awnings
- Hardwired
- 11 - 20 Inch Long
- Cool White
- Optronics
more information >
Continue Researching
- Q&A: Will B&W Gooseneck Pin Box Fit Brinkley Z2900
- Q&A: Do You Have a 14" Wheel w/a 5 on 4-3/4 Bolt Pattern?
- Q&A: Replacement Lights for RV With Lights Taking Water Damage
- Q&A: Can Fuse Tap be Used to Acquire Brake Signal for Brake Controller Install of 2017 Toyota Highlander
- Q&A: Will Dometic CT Thermostat and Control Board Work With Dometic Penguin II With Heat Pump
- Q&A: Replacing A Dometic RV Air Conditioner Rooftop Unit With An Advent Air Unit
- Q&A: Do I Need a Thermostat and a Distribution Box for a Penguin II 651816?
- Article: Trailer Lighting Requirements
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Install an RV Awning From Scratch
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Replace an RV Roof Vent Cover
- Article: How to Replace or Install an RV Roof Vent



