Dimensions, Angle of the Draw-Tite Ball Mount # 40332

Updated 07/31/2014 | Published 07/27/2014

Question:

I am looking for the dimension from the centerline of the ball shank hole to the start of the upturn arm. Additionall, if I could get either the angle of the arm or the horizontal dimension between the start of the arm flush with the upper ball mount surface to the top of the receiver solid bar, it would be most helpful.

asked by: Dave

Expert Reply:

I went out to the warehouse and pulled the Draw-Tite Ball Mount # 40332 and took some measurements for you. The dimension from the center of the ball hole to the upturn of the arm is 2-1/8 inches.

The second measurement, from the upturn to the top of the shank, is 7 inches. See the image showing the dimensions which I have attached for you.

I spoke to the engineer at Draw-Tite who designed the ball mount and he said the angle of the drop is 52.696 degrees.

expert reply by: Chris O