7 and 4-Way Connector for a 2008 Ford Expedition
Published 01/28/2010
Question:
Will this item fit a 2008 Ford Expedition. I want to replace the standard flat 4 plug with this combination plug. and will the connector reach. Thank you in advance
asked by: Mike B
Expert Reply:
Since your truck has a factory 4-Way connector at the rear of the vehicle you will need the Adapter 4 Pole to 7 Pole and 4 Pole, item # 37185, which is designed for the 1997 - 2008 Ford Expedition with factory 4-Flat. The connections for the brake feed, power and axillary functions will be on the forward side of a connector that is attached to the driver side frame rail above the spare tire. You will need to splice the needed connections into the wiring using a circuit tester, item # PTW2993, to find the correct circuit for each wire.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation: Starting from Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Troubleshooting A Thomas Payne Recliner That Will Not Recline
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)