Bolt Hole Spacing For 48" Long Side-Door Bar Lock Assembly PLR24FR
Updated 08/27/2026 | Published 08/19/2026
Question:
BOLT PATTERN FROM CENTER TO CENTER i HAVE A DISCOVERY TRAILER AND DO NOT WANT TO CUT EXTRA HOLES
asked by: MIKE
0
Expert Reply:
Hey Mike, thanks for reaching out. I went out to our warehouse and measured the 48" Long Side-Door Bar Lock Assembly # PLR24FR. The outer set of holes are approximately 46-3/4" apart on center. The inner set of holes are 40-1/4" apart on center. Each set of holes is 3-1/4" apart.
Will that match up with your trailer?
expert reply by:
Jesse M
0
48" Long Side-Door Bar Lock Assembly PLR24FR
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
48" Long Side-Door Bar Lock Assembly
- Trailer Door Latch
- Reversible
- Cam-Action Latch
- Lock Not Included
- Bolt-On
- Zinc-Plated Steel
- Polar Hardware
more information >
Continue Researching
- Q&A: Enclosed Trailer Side Door Frame and Trim
- Q&A: Do the Malone Trailers Come with a VIN That Allows Them to Be Registered and Licensed
- Q&A: Recommended 7-Way Connector for a 2017 Ford Expedition
- Q&A: Parts Needed to Flat Tow a 2013-2015 Smart Fortwo
- Q&A: Hitch Pin Weight Capacity and Sheer Strength
- Q&A: Best Option For Replacing Duo Therm 57912.531
- Q&A: Can Global Link Vise Lock, Entry Door Latch, and Cam Lock Be Keyed Alike
- Article: Trailer Wiring Diagrams
- Article: Converting Your RV Water Heater to Tankless
- Article: How to Install E-Track in 3 Easy Steps
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV