Steel Thickness of Components Measured at 7/8 Inch
Updated 09/02/2026 | Published 08/19/2026
Question:
How thick is the steel that these components are made out of?
asked by: Christian B
0
Expert Reply:
Hi, I went out to our warehouse and measured the steel on these components for you. The Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs part # APT6SE-36 measures approximately 7/8 inch thick. I hope that helps with your project!
Are you looking to replace your hanger kit? I am happy to help.
expert reply by:
Heather A
0
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 13-1/8" Long Equalizers
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Tandem Axle
- Redline
more information >
Continue Researching
- Q&A: Direct Replacement Water Heater for Atwood Model GC10A-4E
- Q&A: Wiring Needed to Connect Electric Brakes on etrailer 7K Axles to Trailer 7-Way
- Article: Most Popular Wheel Bearings
- Q&A: How to Measure For Replacement Slipper Spring Equalizer For Gooseneck Trailer
- Q&A: Recommended Slipper Spring Suspension for 10,000 Pound Trailer
- Q&A: Comparing Bronze and Nylon Bushings for Trailer Suspension
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Q&A: Spring Bolt Hole Separation For 2" Slipper Spring Equalizer in Kit # AP216
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle