Can DeeZee Trailer Tongue Toolbox part # DZ91717P Mount Flush to Front Trailer Wall
Published 07/23/2014 >
Question:
Can the back of the box be mounted flush against trailer and still allow the lid to open up to a full upright position? no space between box and trailer
asked by: Holly
Expert Reply:
The hinge of the DeeZee Specialty Series Trailer Tongue Toolbox part # DZ91717P is located on the back edge of the toolbox so you would not be able to mount this box flush to the front of your trailer.
You will need to mount the box a few inches in front of the front wall of your trailer. Your best bet would be to set the box on the trailer frame and then open the lid and see how much clearance you would need and then mount the box where needed.
I attached an install video for this product for you to check out as well.
Product Page this Question was Asked From
DeeZee Specialty Series Trailer Tongue Tool Box - A-Frame - Plastic - 6 Cu Ft - Black
- Trailer Tool Box
- A-Frame Tool Box
- 15 - 18 Inch Tall
- Plastic
- 31 - 40 Inch Long
- Black
- DeeZee
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can Storage Boxes be Mounted on Front of V-Nose Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Can I Put Four 6 Volt Batteries in the Buyers Products Trailer Tongue Toolbox 3371701385?
- Q&A: Front To Back Measurement On Buyers Products Trailer Tongue Toolbox
- Q&A: What MCD Innovations Shade Motor do I Need to Replace My Motor with mcd.sc.28-12v.1?
- Q&A: Is There a Weld Pattern for the Sleeve-Lock A-Frame Trailer Coupler # CA-5296-B?
- Q&A: Dimensions Of The Valterra RV Gravity Fill Water Inlet Funnel Opening
- Q&A: Replacement Cover/Shroud for Dometic Brisk AC for RV
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Best Running Boards
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Steel vs. Aluminum Ball Mounts


